TS555R-UserGuide - 第12页

12 4. To uch the Check Mark icon to save and exit 5. Press the foot switch to activate the “Timed” dispense cycle. Alternately, touch the run icon on the display to activate the “Timed” dispense cycle. Note: The unit has…

2. Press the “BAR” icon to change pressure unit to BAR

3. Touch the X icon to save and exit

5.2.3 Manual/Purge Dispense Cycle Setting:

1. Touch the Purge icon to select the purge cycle.

The Purge icon will turn to green color.

2. Press and hold down the foot switch to activate the purge dispense cycle.

Alternately, touch and hold the Run icon on the display to activate the

purge dispense cycle.

5.2.4 Automatic Dispense Cycle Setting

1. Touch the “Timed” mode icon to set the dispense cycle in pre-set dispense

time. The icon should turn to green color.

2. Touch the Dispense icon to enter the setup screen

3. Touch the Up and Down arrows to set the desired dispense time.

Note: The minimum activation time is 0.008 second

4. Touch the Check Mark icon to save and exit

5. Press the foot switch to activate the “Timed” dispense cycle.

Alternately, touch the run icon on the display to activate the “Timed”

dispense cycle.

Note: The unit has an “Interrupt” mode feature. In this mode, the

“Timed” dispense cycle can be disrupted if the foot switch is released and

resumed when the Foot Switch is depressed again.

6. Touch the “Interrupt” icon to activate “Interrupt” mode. The icon should

turn to green color.

5.2.5 Teach Mode Setting

In the teach mode, the dispense time will be accumulated as long as the

foot switch is depressed. This is helpful in determining the required

dispense time when the dispense output is known.

1. Touch the “Teach” icon to enter the teach mode

2. Touch the “Time Reset” icon to set timer to zero

3. Press and hold down the foot switch, the dispense time will be accumulated

4. Release the foot switch when the desired amount of fluid has dispensed

5. Touch the “Timed” icon to transfer the accumulated dispense time to

“Timed” mode

6. The unit is now set to repeat this “Timed” cycle

5.3 Stored Program in Memory cell

The unit has 50 memory cells to store all dispense parameters. The controller can

activate all memory cells in sequence mode.

5.3.1 To store dispense parameters

1. Touch the forward or backward arrow to select the desired memory cell.

2. Enter all the desired dispense parameters then touch the “Save” icon to save

the data

5.3.2 To run in Continuous Mode

The controller can be setup to repeat the run continuously.

1. Touch the Setup icon to enter the setup screen

2. Touch the “Run Method” icon