Service Manual SIPLACE SmartFeeder - 第111页

7 Repairs to SmartFeeder 8 mm X / Xi 7.5 Pickup window Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 111 ► Move the feeder module to a position where it is upright and sta…

100%1 / 246
7 Repairs to SmartFeeder 8 mm X / Xi
7.5 Pickup window
110 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
7.5.1 Removing the pickup window
► Carefully place the feeder module with the left
side down on a stable, level and clean surface.
► Remove the two Phillips screws.
► Remove the counterplate.
► Remove the two pressure springs.
7 Repairs to SmartFeeder 8 mm X / Xi
7.5 Pickup window
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 111
► Move the feeder module to a position where it is
upright and stable.
► Tilt the pickup window slightly upwards.
► Carefully lift the pickup window over the pin
wheel.
► Remove the pickup window from the left side.
7.5.2 Fitting the pickup window
► Move the feeder module to a position where it is
upright and stable.
► Carefully lift the pickup window from the lefthand
side over the pin wheel.
7 Repairs to SmartFeeder 8 mm X / Xi
7.5 Pickup window
112 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
► Lift the pickup window slightly upwards and push
it into the prescribed position.
► Carefully place the feeder module with the left
side down on a stable, level and clean surface.
► Insert both pressure springs.
Make sure that the bottom ends of the pressure
springs are not inserted into the groove.
► Insert the nibs of the counterplate into the bottom
ends of the pressure springs.
► Carefully push the counterplate upwards, until
both of the counterplate nibs engage with the
pressure springs in the pickup window.
► Push the counterplate upwards even more, until
the threaded holes of the pickup window are
completely visible in the holes of the counter-
plate.
Make sure that you do not get the counter-
plate(1)
and the actuator(2) jammed against one
another in the marked area.
► Fix the counterplate into place with the two Phil-
lips screws marked.