Service Manual SIPLACE SmartFeeder - 第169页

7 Repairs to SmartFeeder 8 mm X / Xi 7.17 Foil container Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 169 ► Fasten the bottom stiffener with the three screws marked with …

100%1 / 246
7 Repairs to SmartFeeder 8 mm X / Xi
7.17 Foil container
168 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
► Fasten the foil box to the foil stripping unit with
the two TORX screws (RF-SN75-2.5 x 6-9.8,
03033796-xx).
Use a TORX screwdriver, 0.6 Nm, size T8.
► Fasten the empty tape duct to the top stiffener
with the two TORX screws (RF-SN85-2.5 x
7.5-9.8, 03044543-xx).
Use a TORX screwdriver, 0.6 Nm, size T8.
► Fasten the splice sensor filling piece with the
TORX screw (RF-SN85-2.5 x 7.5-9.8, 03044543-
xx).
Use a TORX screwdriver, 0.6 Nm, size T8.
► Insert the flat ribbon cable for the control panel
on the control board as far as the end stop into
connection X202.
Make sure that the contacts are on the underside
of the cable and that the blue side of the cable
can be seen on the top.
► Lock the connection.
7 Repairs to SmartFeeder 8 mm X / Xi
7.17 Foil container
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 169
► Fasten the bottom stiffener with the three screws
marked with A
(RF-SN75-2.5 x 6-9.8, 03033796-
xx).
Use a TORX screwdriver, 0.6 Nm, size T8.
► Fasten the screw marked with B (SN 213307-H-
M2.5 x 5-A2-70, 03071822-xx).
Use a Phillips screwdriver.
► Fasten the left side cover (see 7.3.2 "Fitting the
left side cover" [}102]).
► Carefully place the feeder module on its right
side.
► Fasten the back slide guide (see 7.2.2 "Fitting the
Sliding Guide" [}100]).
► Slightly lift the right side cover at the back.
► Insert the shaft (2).
► From above, fit the flap (1) vertically onto the
shaft.
► Slightly lift the right side cover at the back.
► Push the foil box sheet from behind into the
feeder module.
Align the foil box sheet over the flap shaft so that
the label can be fully seen.
► Carefully place the feeder module with the left
side down on a stable, level and clean surface.
► Fasten the with the screws marked A.
Use a TORX screwdriver 0.6 Nm, size T8.
► Fasten the screw marked with B.
Use a Phillips screwdriver.
7 Repairs to SmartFeeder 8 mm X / Xi
7.17 Foil container
170 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020