Service Manual SIPLACE SmartFeeder - 第195页

8 Repairs to SmartFeeder 2x8 mm X / Xi 8.7 Splice sensor / dummy Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 195 8.7.2 Fitting the splice sensor NOTICE Always fit both s…

8 Repairs to SmartFeeder 2x8 mm X / Xi

8.7 Splice sensor / dummy

194 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020

► Push the dummy sensor approx. 2 mm horizont-

ally to the right.

► Carefully lift the dummy sensor.

Make sure that the two connection lines inserted

into the dummy sensor are not damaged.

► Carefully swing the dummy sensor upwards.

► Pull the cable about 4 cm out of the base unit of

the feeder module.

► Push the connectors of the two cables out to

each side, out of the dummy sensor guidance.

► Remove the dummy sensor.

8 Repairs to SmartFeeder 2x8 mm X / Xi

8.7 Splice sensor / dummy

Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 195

8.7.2 Fitting the splice sensor

NOTICE

Always fit both splice sensors.

If you want to use splice sensors for the feeder module, both lanes need to be supplied with

splice sensors.

When you connect the splice sensors, make sure that you use the right cable for the lane in

each case:

- The cable for the splice sensor on the left lane has the colors red, white and black.

- The cable for the splice sensor on the right lane has the colors red, brown and black.

► Pull the sensor cable for that lane out of the cable

duct.

► Plug the connector for the sensor cable into the

connection on the splice sensor.

► Carefully guide the sensor cable back into the

cable duct.

► Place the splice sensor onto the lane.

Make sure that you do not pinch the cable but

that it is fed into the cable duct properly.

► Push the splice sensorin the direction of the ar-

row, as far as the stop, towards the tape duct.

Make sure that the nib at the front of the splice

sensor is completely inserted into the tape duct.

8 Repairs to SmartFeeder 2x8 mm X / Xi

8.7 Splice sensor / dummy

196 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020

► Fix the splice sensor to the lane with the screws

provided.

► Fit the second splice sensor in the other lane.

The procedure is the same as that for the first

splice sensor.

After installation, the splice sensors will be automatic-

ally recognized and do not require any additional activ-

ation.

8.7.3 Removing the splice sensor

► Remove the screw fastening the splice sensor to

the lane.