Service Manual SIPLACE SmartFeeder - 第52页

6 Repairs to SmartFeeder 4 mm X / Xi 6.8 Foil rocker 52 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 6.8 Foil rocker 6.8.1 Replacing the foil rocker assembly Spare part r…

100%1 / 246
6 Repairs to SmartFeeder 4 mm X / Xi
6.7 Drives
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 51
► Tighten the left-hand side of the spiral gear(12)
with a size 4 Allen key(13) and 0.9 Nm.
► Fit the bearing cap(14) onto the foil stripping
unit, as shown.
► Fasten the bearing cap with the three marked
screws ISO 7046-2-M2.5x 6-A2-70-H (item no
03023228-xx)(15)
, using a Phillips screwdriver
and 0.9Nm.
► Fasten the left side cover (see 6.3.2 "Fitting the
Left Side Cover" [}30]).
6 Repairs to SmartFeeder 4 mm X / Xi
6.8 Foil rocker
52 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
6.8 Foil rocker
6.8.1 Replacing the foil rocker assembly
Spare part required
Fig.10: Foil rocker assembly
NOTICE
New spare part
The new foil rocker has no metal deflector (A). The old foil rocker with metal deflector (B) is
no longer available.
Fig.11: Cable light barrier emitter
Feeder module Item no. Designation
SmartFeeder 4mm X
SmartFeeder 4 mm Xi
03136093-xx Foil rocker unit assy. X4Smart V2 (no longer avail-
able)
03226998-xx Foil rocker assembly X4Smart V3
03063591-xx Cable for light barrier emitter 2x8
Tools required
●
Flat-bladed screwdriver size 1 or tweezers
●
TORX screwdriver size T8
6 Repairs to SmartFeeder 4 mm X / Xi
6.8 Foil rocker
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 53
6.8.1.1 Removing the Foil Rocker Assembly
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Remove the two screws(1) which fasten the foil
rocker.
Use a size T8 TORX screwdriver for this.
► Pull the foil rocker up and off(2).
► Make sure that the flat ribbon cable(3) is not
stretched too much.
► Turn the foil rocker into the position shown in the
diagram.
► Swing the holder on the flat ribbon connection
up(4).
► Pull the flat ribbon cable(5) out of the flat ribbon
cable connection.