Service Manual SIPLACE SmartFeeder - 第60页
6 Repairs to SmartFeeder 4 mm X / Xi 6.9 Rocker 60 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 6.9.1.2 Fitting the rocker assembly ► Carefully place the feeder module wi…
6 Repairs to SmartFeeder 4 mm X / Xi
6.9 Rocker
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 59
6.9.1.1 Removing the rocker assembly
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Use a size 1 flat-bladed screwdriver to loosen the
bearing shaft (1)
for the rocker.
► Press down on the rocker from above, to take the
tension off the bearing shaft.
► Pull the bearing shaft upwards and out with flat
pliers or a similar tool.
► Lift the rocker up and out of the feeder module.
► Remove the pressure spring.
6 Repairs to SmartFeeder 4 mm X / Xi
6.9 Rocker
60 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
6.9.1.2 Fitting the rocker assembly
► Carefully place the feeder module with the right side
down on a stable, level and clean surface.
► Fit the pressure springs into the feeder module base
unit.
► Push the pressure spring sideways into the rocker
guidance.
► Press the rocker from above (as shown) into a posi-
tion from which you have a full view of the bearing
shaft hole.(1)
► Insert the bearing shaft with its thread first into this
hole.(2)
► Fasten the bearing shaft hand-tight with a size 1 flat-
bladed screwdriver.
6 Repairs to SmartFeeder 4 mm X / Xi
6.9 Rocker
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 61
6.9.2 Replacing individual rocker parts
Required spare parts:
Fig.14: Individual rocker parts
Feeder module Position Item no. Designation
SmartFeeder 4mm X
SmartFeeder 4 mm Xi
1 03135354-xx Rocker for foil disposal X4Smart
2 03135459Sxx Cover plate, rocker V2 X4Smart
3 00322564-xx SN 213307-H-M2 x 4-A2
4 03156694-xx Tamp wheel assy. steel X4Smart
5 03042321-xx Bearing shaft for rocker /X8
Tools required:
●
Flat-bladed screwdriver size 1
●
TORX screwdriver T8
6.9.2.1 Removing the individual parts of the rocker
To gain access to the individual spare parts of the
rocker foil disposal assembly, first remove the cover
plate.
► Remove the screw(1), fastening the cover plate.
Use a size T8 TORX screwdriver for this.