Service Manual SIPLACE SmartFeeder.pdf - 第80页
6 Repairs to SmartFeeder 4 mm X / Xi 6.15 Handle with control panel 80 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 6.15.3.2 Fitting individual parts to the handle ► Hold…
6 Repairs to SmartFeeder 4 mm X / Xi
6.15 Handle with control panel
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 79
6.15.3.1 Removing individual parts from the handle
► Carefully place the feeder module with the right side down on a stable, level and clean sur-
face.
► Remove the left side cover (see 6.3.1 "Removing the Left Side Cover" [}30]).
► Remove the control panel (see 6.15.2.1 "Removing the Control Panel and Board" [}76]).
If you have removed the control panel, the cover on the foil stuffing unit will be accessible and can
be replaced if necessary.
► Pull the slide up and out of the handle. (1)
► Remove the pressure spring.(2)
► Remove the TORX screw which fastens the
spring hook(1)
to the handle.
► Remove the spring hook.
6 Repairs to SmartFeeder 4 mm X / Xi
6.15 Handle with control panel
80 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
6.15.3.2 Fitting individual parts to the handle
► Hold the spring hook as shown(1) by the handle,
so that you can look through the opening and see
the hole for the screw.
► Screw the spring hook to the handle. Use a size
T8 TORX screwdriver with 0.6 Nm for this.
► Push one end of the pressure spring in the
handle, as shown.(1)
► Insert the slide into the other end of the pressure
spring.(2)
► Press the slide into the pressure spring and insert
it from above, into the handle.(3)
At this point, the cover on the foil stuffing unit will be accessible and can be replaced if necessary,
before you fit the control panel.
► Fasten the control panel (see 6.15.2.2 "Fitting the Control Panel and Board" [}77]).
► Fasten the left side cover (see 6.3.2 "Fitting the Left Side Cover" [}30]).
6 Repairs to SmartFeeder 4 mm X / Xi
6.16 Control board
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 81
6.16 Control board
CAUTION
Electrostatic charge
When removing and fitting the control board, observe the currently applicable ESD
guidelines.
Required spare part
Fig.24: Example control board X8Smart V2
Feeder module Item no. Designation
SmartFeeder 4mmX (V2) 03101127-xx Control board X8Smart V2
SmartFeeder 4mmX (V3) 03124276-xx Control board X8Smart V3
SmartFeeder 4 mm Xi 03160015-xx Control board X8Smart Xi
Tools required
●
Phillips screwdriver 0.9Nm
●
TORX screwdriver 0.6Nm and 0.2 Nm, size T8