Service Manual SIPLACE SmartFeeder - 第95页
6 Repairs to SmartFeeder 4 mm X / Xi 6.17 Foil container Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 95 ► Insert the pressure spring back into the rocker. ► Carefully pl…
6 Repairs to SmartFeeder 4 mm X / Xi
6.17 Foil container
94 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020
► Fasten the splice sensor filling piece with the
TORX screw (RF-SN85-2.5 x 7.5-9.8, 03044543-
xx).
Use a TORX screwdriver, 0.6 Nm, size T8.
► Insert the flat ribbon cable for the control panel
on the control board as far as the end stop into
connection X202.
Make sure that the contacts are on the underside
of the cable and that the blue side of the cable
can be seen on the top.
► Lock the connection.
► Fasten the bottom stiffener with the three screws
marked with A
(RF-SN75-2.5 x 6-9.8, 03033796-
xx).
Use a TORX screwdriver, 0.6 Nm, size T8.
► Fasten the screw marked with B (SN 213307-H-
M2.5 x 5-A2-70, 03071822-xx).
Use a Phillips screwdriver.
► Fasten the left side cover (see 6.3.2 "Fitting the
Left Side Cover" [}30]).
► Fasten the left side cover (see 6.3.2 "Fitting the
Left Side Cover" [}30]).
6 Repairs to SmartFeeder 4 mm X / Xi
6.17 Foil container
Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020 95
► Insert the pressure spring back into the rocker.
► Carefully place the feeder module with the left
side down on a stable, level and clean surface.
► Remove the screws marked in the diagram.
You need a Phillis screwdriver for the screws marked
(1)
and (2).
Use a size T8 TORX screwdriver for the screw at (3).
► Carefully place the feeder module with the left
side down on a stable, level and clean surface.
► Inserting the (new) insertion foil container.
► Fasten the insertion foil container with the 4
TORX screws marked in the diagram
(RF‑SN75‑2.5 x 6‑9.8, 03033796‑xx).(1)
Use a TORX screwdriver 0.6Nm, size T8 for this.
► Fasten the Phillips screw (ISO 7045 - M2.5 x 6-
A2-50-H, 03010209‑xx).(2)
► Insert the shaft in the position shown into the in-
sertion foil container, as far as the stop.(3)
► Push the flap onto the shaft.(3)
► Fit the right side cover (see6.3.4 "Fitting the Right
Side Cover" [}32]).
► Fasten the back slide guide (see 6.2.2 "Fitting the
Sliding Guide" [}28]).
6 Repairs to SmartFeeder 4 mm X / Xi
6.17 Foil container
96 Service Manual SIPLACE SmartFeeder 4 - 8 mm X / Xi SIPLACE SmartFeeder 2 x 8 mm X / Xi 11/2020