YSD_Users_E.pdf - 第111页

2-51 2 Basic operation 5 P ass the paper through the paper guides. Referring to the figure at the right, pass the paper in order thr ough the guides as shown at the Step2. n NOTE T o pass the paper through the roller sec…

100%1 / 401
2-50
2
Basic operation
4.2 Dot station
4.2.1 Replacing the paper
To replace the predispensing paper in the dot station, use the following procedure.
1
Remove the paper feed unit.
Holding the handles at both ends, remove
the paper feed unit by pulling it to the front.
Removing the paper feed unit
Paper replacement section
Handle
Diffuser section
63214-N7-00
2
Remove reel 1.
Remove reel 1 on the roll-up side.
Passing the paper through the unit
Paper guide
Reel 1
Roller section
Installation shaft
Reel 2
63215-N7-00
3
Remove the used roll of paper from reel 2.
If it is difficult to remove, cut into the roll with a cutter and remove the used roll.
4
Attach a roll of new paper.
Insert the new paper onto the paper installation shaft as shown above.
2-51
2
Basic operation
5
Pass the paper through the paper guides.
Referring to the figure at the right, pass the paper in order through the guides as shown at the Step2.
n
NOTE
To pass the paper through the roller section, push the roller against the feeding reel.
6
Insert the end of the paper into a slit in the shaft.
1. Insert the end of the paper into a slit in the shaft of reel 2.
2. Rotate the gear on which the reel drive belt is fit so that reel 2 rotates counterclockwise two or three
turns. Reattach reel 1 to hold the paper.
Inserting the paper into the reel
Paper
Sit
Gear
63216-N7-00
7
Reattach the paper feed unit.
Install the paper feed unit in the original position.
n
NOTE
If the diffuser section gets dirty, it should be dry-wiped with a cleaning wipe.
8
Advance the paper manually.
On the Setup screed, press the [Dot Station] button to open the “Dot Station” dialog box, and press the
[Start] button to advance the paper to take up the slack in the paper. After the slack is taken up, press
the [Stop] button and close the dialog box.
Advancing the dot station paper
64243-N7-00
2-52
2
Basic operation
4.3 Laser displacement meter
4.3.1 Initialization
The laser displacement meter can be initialized (reset to zero) at a specified position. To do this, open the
Setup screen and press the [Reset Laser] button under "Utility". Then move the laser displacement meter to the
position where you want to set "zero point" for the laser.
When the dispense nozzle has been replaced or after the power is turned on, always reset the laser
displacement meter to zero with the [Reset Laser] button. In addition, use the [Nozzle Length] button on the
Setup screen to measure the dispense nozzle length with a touch sensor.
[Reset Laser] and [Nozzle Length] buttons
64244-N7-00
n
NOTE
When using board data specified for use with the laser displacement meter, an error message will appear if you
attempt to start automatic operation without resetting the laser displacement meter to zero.