88192278-01-19 Installation Master - 第114页
PRINTER PREPARATION TRANSIT BRACKETS AND SCREWS REMOVAL 4.12 Installation Manual Chapter Issue 15, May 20 Camera T ransit Screws (Linear Drive) 1. Loosen the lock nut that secures the transit screw to the camera Y plate.…
PRINTER PREPARATION
TRANSIT BRACKETS AND SCREWS REMOVAL
Chapter Issue 15, May 20 Installation Manual 4.11
Paste Dispenser
Transit Screw
1. Remove the paste dispenser transit screw that secures the belt clamp
bracket to the paste dispenser mounting tray.
Camera Transit
Screws (Rotary
Drive)
1. Remove the transit screw that secures the camera beam to the camera X
drag chain bracket.
2. Remove the transit screw that secures the camera Y drag chain bracket to
the right hand printhead.
View on Right Hand Underside of Paste Dispenser
Transit Screw
Paste Dispenser Mounting Tray
Belt Clamp Bracket
Note
Camera X Drag Chain Bracket is hidden
from view by the Camera Beam
Transit Screws
Camera Beam
Right Hand Printhead
Camera Y Drag
Chain Bracket
PRINTER PREPARATION
TRANSIT BRACKETS AND SCREWS REMOVAL
4.12 Installation Manual Chapter Issue 15, May 20
Camera Transit
Screws (Linear
Drive)
1. Loosen the lock nut that secures the transit screw to the camera Y plate.
2. Remove the transit screw that secures the camera Y plate to the camera Y
linear bearing ensuring that the lock nut and crinkle washer are removed
with the transit screw.
3. Remove the transit screw that secures the camera X drag chain bracket to
the camera beam extrusion.
Under Screen
Cleaner
1. Snip the cable ties securing the piece of card to the top of the under screen
cleaner.
2. Remove the cable ties and the piece of card from the printer.
This concludes the transit bracket and screw removal procedure. Transit
brackets, screws and associated fasteners should be stored for future reuse.
Printer Relocation In the event of printer relocation, refer to the Technical Reference Manual,
Transportation chapter for transit bracket and screw fitment procedure.
View on Right Hand Underside of Camera Beam
Transit Screw
Transit Screw
Camera Y Plate
Camera Y Linear Bearing
Camera X Drag Chain Bracket
Camera Beam Extrusion
Lock Nut and
Crinkle Washer
PRINTER PREPARATION
PRINTER HEIGHT AND LEVELLING
Chapter Issue 15, May 20 Installation Manual 4.13
PRINTER HEIGHT AND LEVELLING
Leg Spacers
(Camera Linear
Drive Printer Only)
The mounting feet on the camera linear drive printer must be kept as short as
possible to reduce vibration and oscillation.
To achieve the height required, 8 leg spacers (maximum of two per foot) are
supplied. The leg spacers interlock together and the printer foot locates in the
recess of the top leg spacer.
1. Using the table below, determine the amount of leg spacers to achieve the
required printer height:
NOTE
The amount of exposed thread of the printer leg should be kept to a mini-
mum to ensure printer accuracy remains within limits.
2. Place the correct number of leg spacers under each corner mounting foot.
Do not place leg spacers under the centre rear mounting foot. Lower the
printer ensuring that each foot is located inside the recessed top, figure
below refers.
NOTE
Do not attempt to manoeuvre the printer into position whilst mounted on the
leg spacers. The printer must be lifted, moved and lowered ensuring that
the leg spacers are moved with the printer.
Transport Height Leg Spacers Required
840mm - 895mm 0
896mm - 940mm 1
941mm - 980mm 2
Leg Spacers
(2 shown)
Machine Mounting Foot
M24 Locking Nuts
Machine Frame
Leg Adjusting Nut