88192278-01-19 Installation Master - 第151页
PRINTER PREPARATION PRINTER ASSEMBLY Chapter Issue 15, May 20 Installation Manual 4.49 NOTE Auxiliary conveyor height settings and paralle lism is checked after Printer Power Up Sequence. ProFlow & ProFlow AT x The p…
PRINTER PREPARATION
PRINTER ASSEMBLY
4.48 Installation Manual Chapter Issue 15, May 20
conveyor in the X and Y planes.
4. If adjustment is required, carry out the following:
a. By careful adjustment of the grub screws on the top face of the auxiliary
conveyor front and rear linear bearing holders, raise or lower the height
of the conveyor about the auxiliary conveyor height adjustment bolt, to
achieve conveyor levelness.
b. Carry out Steps 2 and 3 to re-check for conveyor levelness.
View on Auxiliary Conveyor
Y
Board Clamp
Setting Plate
Spirit Level
X
Front View of HTC Rails
Grub Screw
Linear Bearing
Linear Bearing Holder
PRINTER PREPARATION
PRINTER ASSEMBLY
Chapter Issue 15, May 20 Installation Manual 4.49
NOTE
Auxiliary conveyor height settings and parallelism is checked after Printer
Power Up Sequence.
ProFlow & ProFlow
ATx
The printer is shipped with the squeegee mechanism fitted as standard. To
change the printer to ProFlow or ProFlow ATx, use the following procedures:
• Remove Squeegee Pressure Mechanism
• Remove Drip Tray
Remove Squeegee
Pressure
Mechanism
To remove the squeegee pressure mechanism, carry out the following
procedure:
1. Disconnect the four squeegee mechanism connectors from the print
carriage, left hand side:
• Rear Squeegee Motor
• Front Squeegee Motor
• Home Sensors
• Squeegee Pressure Amplifier
2. Loosen the four captive screws securing the squeegee printhead
mechanism to the print carriage using a 4mm Allen key. Carefully remove
Rear Squeegee
Motor (9SK17)
Front Squeegee
Motor (9SK16)
Home Sensors
(9SK08)
Squeegee Pressure
Amplifier (N3SK16)
PRINTER PREPARATION
PRINTER ASSEMBLY
4.50 Installation Manual Chapter Issue 15, May 20
the mechanism from the print carriage.
Removing Drip Tray 1. Close the speed control valves on the drip tray actuator.
2. Remove the securing screw attaching the drip tray to the actuator piston.
3. Slide the drip tray off the bearing on the drip tray guide shaft.
4. Remove the drip tray guide shaft if fitting ProFlow ATx.
Captive Screw (in 4 positions)
Drip Tray
Drip Tray Guide Shaft
Securing Screw
Speed Control Valves