88192278-01-19 Installation Master - 第26页

SAFETY FEATURES GENERAL 1.14 Installation Manual Chapter Issue 15, Nov 19 •L i d B o l t • Moving Rail Stepper • Print Carriage Servo (axis stopped before power is removed) • Paste Cartridge T ilt Up/T ilt Down Pneumatic…

SAFETY FEATURES

GENERAL

Chapter Issue 15, Nov 19 Installation Manual 1.13

Figure 1-5 Type 5

Emergency Stop

(E Stop)

The printer is fitted with an E Stop which suspends all printer operations. The

switch is within easy reach of the operator and once pressed, the latching switch

requires resetting.

To reset the E Stop, turn the button clockwise until it unlatches.

Pressing the E Stop or opening the printhead cover cuts the servo axes power

supply. A warning of this condition is reported on the printer monitor.

E Stop Module

Shut Down

If the E Stop loop is opened by pressing the E Stop or opening the printhead

cover, an emergency stop is initiated via the E Stop module. When actuated the

following areas of the printer are rendered inactive:

SAFETY FEATURES

GENERAL

1.14 Installation Manual Chapter Issue 15, Nov 19

•Lid Bolt

• Moving Rail Stepper

• Print Carriage Servo (axis stopped before power is removed)

• Paste Cartridge Tilt Up/Tilt Down Pneumatic Actuator

• Paste Dispense Solenoid and Stepper Motor

• Rail System Front and Rear Belt Motor Drives

• Rising Table Brake (brake engages when power is cut)

• Rising Table Servo

• Squeegee/ProFlow Stepper Motor(s)

• System Lamp

• Under Stencil Cleaner Fabric Feed Motor

• Under Stencil Cleaner Solvent Pump

• Under Stencil Cleaner Squeegee Solenoid

• Vacuum Tooling Solenoid

• X Camera Motor (axis stopped before power is removed)

• X Forward, X Rear and Y Chase Alignment Stepper Motors

• Y Camera Motor (axis stopped before power is removed)

NOTE

The pass through lane belt motors on the Dual Lane printer continue running

when the printhead cover is open but stop when the E Stop is pressed.

Recovery When normal working conditions are restored, release the E Stop switch and,

when prompted by a screen message, press the System button.

Opening Covers Opening printhead covers are fitted with a cam interlock switch to protect

personnel from internal moving parts.

Lid Bolt Lid bolts are fitted to all opening printhead covers to prevent them from being

raised during the print cycle.

The lid bolts are withdrawn and the printhead cover may be raised when:

• Open Cover is requested by software

• Pause or stop is selected during a print cycle

• The E Stop is pressed

SAFETY FEATURES

GENERAL

Chapter Issue 15, Nov 19 Installation Manual 1.15

Jog Buttons The two button control switches or jog buttons are positioned such as to

maintain maximum safety for the operator whilst solvent priming or paper

feeding with the printhead cover open. This requires both buttons to be

depressed simultaneously for the function to become active. The use of these

buttons is dependent on the function selected on the printer monitor. During

normal operation these buttons control paper feed and solvent prime opera-

tions. When in maintenance mode, the two button control switches control the

movement of the following diagnostics:

• Print Carriage

• Squeegee Assembly

• Camera Axes

• Rail System

• Stencil Alignment

• Rising Table

• ProFlow

• Paste Dispenser

Only one button is required to drive the selected mechanism, the two buttons

are used to drive the mechanism in opposite directions, ie jog forward or jog

back.