88192278-01-19 Installation Master - 第51页

COVERS PRINTER COVERS Chapter Issue 12, Feb 18 Installation Manual 2.17 7. Release the front and rear quarter-turn ring latch es located above the front and rear corner panels respectively . 8. Pull the top edge of the c…

COVERS

PRINTER COVERS

2.16 Installation Manual Chapter Issue 12, Feb 18

Upper Side Panels To remove an upper side panel, carry out the following:

1. Lift the sliding cover.

2. Lift the rear printhead cover.

3. Remove the safety cover.

4. At the front of the upper side panel, remove the appropriate upper panel

switch contact blocks (System, Jog or Internal light.) The blocks are located

at the rear of the switch bezel.

5. The contact block can be separated from the bezel, (hold the body part to

remove the contact blocks, not the switch wires) by pulling it out of the bezel.

When refitting, the contact body is aligned with the bezel.

6. Release the quarter-turn ring latch fastener, located internally at the top front

of the cover.

Switches (System, Jog)

COVERS

PRINTER COVERS

Chapter Issue 12, Feb 18 Installation Manual 2.17

7. Release the front and rear quarter-turn ring latches located above the front

and rear corner panels respectively.

8. Pull the top edge of the cover out to release the locating tabs from the top

edge.

Quarter-Turn Ring Fastener

Panel Locating Tabs

COVERS

PRINTER COVERS

2.18 Installation Manual Chapter Issue 12, Feb 18

The panel can be ‘hinged’ away to release the bottom tabs from the support

rail. Lift the panel out of position.

NOTE

When refitting the right hand panel, ensure that the cables from the MMI are

routed in the support arm groove.

Dowel Pin