88192278-01-19 Installation Master - 第69页
COVERS PRINTER COVERS Chapter Issue 12, Feb 18 Installation Manual 2.35 Upper Front Corner Panels T o remove the upper front corner panels, carry out the following: 1. Open the front printhead cover . NOTE 1. Before a fr…
COVERS
PRINTER COVERS
2.34 Installation Manual Chapter Issue 12, Feb 18
3. Using a 4mm Allen key, undo the appropriate two captive screws.
4. Lift the panel clear of the location pins that locate the panel to the printer
frame, taking care not to damage the earth cable.
5. Repeat Steps 3 and 4 for the other rear corner panel, if required.
Front Right Quarter View
Captive Screws
COVERS
PRINTER COVERS
Chapter Issue 12, Feb 18 Installation Manual 2.35
Upper Front Corner
Panels
To remove the upper front corner panels, carry out the following:
1. Open the front printhead cover.
NOTE
1. Before a front corner panel can be removed, the control switches (jog
switch and system switch) must be disconnected.
2. Before removing the upper front corner panel, disconnect the connector
for the printhead safety switch.
2. To disconnect the system switch and jog buttons carry out the following:
a. Locate the two release slots in the contact assembly part of the switch.
b. Insert the switch release tool (Part No 188647) into the slots and push
View on Rear of Switch
1 Release Slot 3 Switch Body
2 Contact Assembly
COVERS
PRINTER COVERS
2.36 Installation Manual Chapter Issue 12, Feb 18
until the release tool clicks into place.
c. Leaving the switch release tool in position, pull the contact assembly from
the switch body.
d. Remove the switch release tool from the contact assembly.
NOTE
To refit the contact assembly to the switch body, using the locating
keyway, push the two units together until they click into place.
3. Using a 4mm Allen key, undo the appropriate four captive screws.
View on Rear of Switch
1 Switch Body
2 Contact Assembly
3 Switch Release Tool