88192278-01-19 Installation Master - 第83页
COVERS PRINTER COVERS Chapter Issue 12, Feb 18 Installation Manual 2.49 NOTE T o refit the contact assembly to the switch body , using the locating keyway , push the two units together until they click into place. 4. Usi…
COVERS
PRINTER COVERS
2.48 Installation Manual Chapter Issue 12, Feb 18
3. To disconnect the system switch and jog buttons carry out the
following:
a. Locate the two release slots in the contact assembly part of the switch.
b. Insert the switch release tool (Part No 188647) into the slots and push
until the release tool clicks into place.
c. Leaving the switch release tool in position, pull the contact assembly from
the switch body.
d. Remove the switch release tool from the contact assembly.
View on Rear of Switch
1 Switch Body
2 Contact Assembly
3 Switch Release Tool
COVERS
PRINTER COVERS
Chapter Issue 12, Feb 18 Installation Manual 2.49
NOTE
To refit the contact assembly to the switch body, using the locating
keyway, push the two units together until they click into place.
4. Using a 4mm Allen key, undo the appropriate four captive screws.
5. Remove the panel clear of the machine, taking care not to damage
the earth cable.
6. Repeat Steps 3 to 4 for the other upper front corner panel, if
required.
COVERS
PRINTER COVERS
2.50 Installation Manual Chapter Issue 12, Feb 18
Lower Side Panels
MANDATORY
HEAVY OBJECT. LIFTING OR RESITING MUST BE UNDERTAKEN BY TWO
PEOPLE.
To remove the lower side panels, carry out the following:
1. Remove the corresponding safety cover (as detailed previously).
2. Open the front printhead cover.
3. Using an 4mm Allen key, undo the four captive screws.
4. Tilt the top of the panel away from the printer and lift the panel clear, taking
care not to damage the earth cable.
5. To disconnect the E Stop from the lower left side panel, turn the latch anti-
Front Left Quarter View
Captive Screws