00197280-01_JG_MultiGripper_EN - 第8页
Multi-Gripper-Kit – How to select the matching ja ws 8 – H o w t o s e le c t t h e m a t c h in g ja w s ► Measure the component at the position you want to grip it. ► Add 1 mm sp ace to the measured value so that the g…
Multi-Gripper-Kit – Overview
7
Multi-Gripper-Kit – How to select the matching jaws
8
– How to select the matching jaws
► Measure the component at the position you
want to grip it.
► Add 1 mm space to the measured value so
that the gripper is able to grip the
component. Depending on the accuracy of
your engine this tolerance might be larger.
► Select the jaws in the table.
Multi-Gripper-Kit – Fitting the jaws
9
– Fitting the jaws
► Tighten the jaws to the gripper base hand
tight.
Depending on the jaw type the two screws have
to be outside (100 – 500) or inside (600 – 800).
Attention:
To be sure, take a look at the jaws.
The engraved type designation must always be
inside.
Warning:
Never remove the four screws of the gripper
base, otherwise the gripper base might get
damaged.
Note:
For long-term applications we recommend to
tighten the screws with a torque wrench and a
torque of 12 Ncm.