Micron Technical Reference V9 Volume 1 - 第145页
MACHINE CONTROL OVERVIEW Chapter Issue 12, Feb 18 Technical Reference Manual 7.1 CHAPTER 7 MACHIN E CONTROL OVER VIEW NOTE Node boards 1, 2, 4, 5 and servo node 9 are positioned and accessed from the front of T ype 4 mac…
MACHINE PC H81
PERIPHERAL DEVICES
6.8 Technical Reference Manual Chapter Issue 3, Feb 18
PERIPHERAL DEVICES
DVD ROM Drive The 5.25 inch DVD ROM Drive is located at the top front of the enclosure and
is used for installing machine software.
MACHINE CONTROL
OVERVIEW
Chapter Issue 12, Feb 18 Technical Reference Manual 7.1
CHAPTER 7 MACHINE CONTROL
OVERVIEW
NOTE
Node boards 1, 2, 4, 5 and servo node 9 are positioned and accessed from the
front of Type 4 machines
Item Node Description
1 Servo Node 8 Camera X Motor (Rotary Servo Drive Only)
2 Stepper Node 10 Paste Dispenser Motor
3 Servo Node 7 Print Carriage Motor
4 I/O Node Board 3 (behind panel) Print Carriage I/O
5 Servo Node 6 Rising Table Motor
6 I/O Node Board 1 (NextMove ES) Inside Machine Control Enclosure
7 I/O Node Board 4 (with fabric feed brake module) Screen Cleaner I/O
8 I/O Node Board 2 Main Machine I/O
9 I/0 Node Board 5 Shared functionality OTS and HTC
10 I/O Node 18 Proactiv Interface
11 Servo Node 9 Camera Y Motor (Rotary Servo Drive Only)
1
2
3
4
5
6
7
8
11
10
9
MACHINE CONTROL
OVERVIEW
7.2 Technical Reference Manual Chapter Issue 12, Feb 18
All machine functions are initiated by the DEK software installed on the PC. The
PC transmits and receives information to the NextMove ES card in the M36
Machine Control Enclosure using a single USB lead. The NextMove ES card
incorporates its own processor which handles machine motions and switch/
sensor feedback, this frees up the PC processor to run the MMI and other
peripherals.
The NextMove ES card incorporates a USB encoder/decoder and a CAN
encoder/decoder interfacing between the PC and the following:
• NextMove Interface Card
• Stepper Drive Cards
• EF Servo Drive Cards
• I/O Node Boards (via CAN Bus)
• Servo/Stepper Nodes (via CAN Bus)
CAUTION
ANTI-STATIC HANDLING.
Standard precautions must be adhered to when
handling electronic cards and configuring and inserting into the enclo-
sures.
NOTE
ASM recommends an antistatic wrist band that incorporates a 1 meg ohm
resistor.
Figure 7-1 Antistatic Wrist Band Connection
ESD Connection