Micron Technical Reference V9 Volume 1 - 第221页

PRINT CARRIAGE MODULE ADJUSTMENTS AND SETTINGS Chapter Issue 5, Aug 14 Technical Reference Manual 8.5 ADJUSTMENTS AND SETTINGS Home Sensor Adjustment W A RNING BOARD CLAMPS. EXTREME CA RE MUST BE EXERCIS ED WHEN WORKING …

100%1 / 290
PRINT CARRIAGE MODULE
ELECTRICAL SCHEMATIC
8.4 Technical Reference Manual Chapter Issue 5, Aug 14
ELECTRICAL SCHEMATIC
N7SK2
24V US (Motor Logic)
M37 Power Supply Module
Print Carriage
Print Carriage Motor
Node 7
1
2
4
5
Servo DC Supply
0V Return
0V Return
1
2
3
4
Power Distribution
PCB
N7PL1
1
2
3
0V
Signal
24V
9SE03
0V
Signal
24V
(L)
Print Carriage
Home 9SE3
Fork Opto
M37PL17
N7PL4
7
2
3
CAN GND
CAN_L
CAN_H
CAN Out
N7SK3
7
2
3
CAN_L
CAN GND
I/O Node 3
N3SK3
2
3
7
CAN_H
CAN_L
CAN GND
CAN_H
PC
M36 Machine
Control Enclosure
USB
Motherboard
NextMove ES
(I/O Node 1)
1
2
4
CAN_H
CAN_L
CAN GND
M36PL35
N3SK2
2
3
7
CAN_H
CAN_L
CAN GND
CAN
Encoder/
Decoder
CAN
Encoder/
Decoder
Temperature
& Humidity
Sensor
NOTE
The breaks in the CAN Bus chain reflect that additional I/O N odes
may be fitted, refer to Machine C ontrol chapter for the com plete
CAN Bus chain. For print carriage solenoid schem at
ic see P neum at
ic
M odule chapter
.
CAN Bus
PRINT CARRIAGE MODULE
ADJUSTMENTS AND SETTINGS
Chapter Issue 5, Aug 14 Technical Reference Manual 8.5
ADJUSTMENTS AND SETTINGS
Home Sensor Adjustment
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
1. Select Unload Screen.
2. Open the front printhead cover
3. Remove the stencil from the machine.
4. Close the front printhead cover.
5. Press the System button.
6. Select Maintenance.
7. Select Diagnostics.
8. Use Next or Previous to highlight Print Carriage.
9. Select Select Module.
10. Ensure that Home Print Carriage is highlighted.
11. Select Run Diagnost.
12. Use Next or Previous to highlight Drive Carriage To Rear Position.
13. Select Run Diagnost.
14. Open the front printhead cover.
PRINT CARRIAGE MODULE
ADJUSTMENTS AND SETTINGS
8.6 Technical Reference Manual Chapter Issue 5, Aug 14
15. Measure the horizontal distance between the inside face of the front rail belt
support plate and the print carriage machined face, (squeegee/ProFlow
interface area), the correct setting being 612.0mm +/- 2.0mm.
16. If the adjustment is correct go to Step 22.
Front Rail
Machine Plan View
Print Carriage Machined Face
Home Sensor
Vane
Right Hand
Printhead
View on Arrow A
View on Arrow B
Belt Support Plate
612mm +/- 2.0mm612mm +/- 2.0mm
A
B