Micron Technical Reference V9 Volume 1 - 第263页
PROACTIV ADJUSTMENTS AND SETTINGS Chapter Issue 5, Jan 15 Technical Reference Manual 10.13 the following graphic: 17. Fit the calibration jig to the front squeegee position using the oute r mounting Mounting Plate Mounti…
PROACTIV
ADJUSTMENTS AND SETTINGS
10.12 Technical Reference Manual Chapter Issue 5, Jan 15
NOTE
Ensure that the rising table print reference height is set correctly before com-
mencing, (the calibration relies upon accurate positioning of the table to make
a reference).
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
1. Select Open Cover Commands.
2. Select Carriage To Rear.
3. Select Unload Screen.
4. Open the front printhead cover.
5. Remove the screen from the machine.
6. Remove the tooling from the tooling plate.
7. Close the front printhead cover.
8. Press the System button.
9. Select Back.
10. Select Maintenance.
11. Select Calibrations.
12. Select Pressure.
13. Select Calibrat Readings. The rails are checked for the presence of a
board, the print carriage moves to the calibration position, the rear rail
moves to home position, the table homes and the board clamps are closed.
14. The machine cover is unlocked and the message ‘Fit the pressure calibra-
tion rig.’ is displayed with the following window:
15. Open the front printhead cover.
16. Ensure that the calibration jig is secured to the mounting plate as shown in
CALIBRATION DATA
Gain Factor
1.02
PROACTIV
ADJUSTMENTS AND SETTINGS
Chapter Issue 5, Jan 15 Technical Reference Manual 10.13
the following graphic:
17. Fit the calibration jig to the front squeegee position using the outer mounting
Mounting Plate
Mounting Holes
Calibration Jig
A
A
S
S
PROACTIV
ADJUSTMENTS AND SETTINGS
10.14 Technical Reference Manual Chapter Issue 5, Jan 15
holes on the front foot assembly.
18. Fit the squeegee pressure plate to the rising table ensuring that the locating
dowels insert into the holes of the rising table.
NOTE
During the squeegee pressure calibration the dwell height of the rear
squeegee is 15mm regardless of the set up value. This height is set during
calibration only.
19. Switch the force meter ON and check the reading is 0kg, (ensure the force
meter is not in contact with the squeegee pressure plate).
20. Select Continue.
View on Frontof Rising Table and Squeegee M echanism
Squeegee Pressure Plate
Locating Dowel
(in 2 positions)
O
OFF
I
ON
UNITS
Zero
MAX TXD
RESET
00.00
Portable Force Gauge
(Calibration Jig)