JANETS_INM - 第335页

JaNets In structio n Manual 7. Program Editor 7- 128 (12) Replacement cont ents ( Chec k (T ombst one Det ection)) This section de scribes data t o be replaced that is set on the “ Chec k (T ombstone Detect ion) ” screen…

JaNets Instruction Manual 7. Program Editor

7-127

(10) Replacement contents (Placement Conditions (Placement Conditions General Settings))

Set data on the component placement conditions to be replaced on the “Placement Condi-

tions (Placement Conditions General Settings)” screen.

Figure 7.6-14 “Replacement contents (Placement Conditions

(Placement Conditions General Settings))” screen

(11) Replacement contents (Placement Conditions) for an RX-6 series

This section describes data to be replaced that is set on the “Placement Conditions (RX-6

series)” screen as a typical example.

Figure 7.6-15 “Replacement contents

(Placement Conditions (RX-6 Series))” screen

Select “Placement

Conditions” from the

tree view to display the

“Placement Conditions

General Settings”

screen.

Select “Placement Condi-

tions” from the tree view

to display the “Placement

Conditions General Set-

tings” screen. Then, open

the RX-6 series screen on

the right side.

JaNets Instruction Manual 7. Program Editor

7-128

(12) Replacement contents (Check (Tombstone Detection))

This section describes data to be replaced that is set on the “Check (Tombstone Detection)”

screen as a typical example.

Figure 7.6-16 “Replacement contents (Check (Tombstone Detection))” screen

(13) Replacement contents (Clinch)

The data substituted by Clinch Item will be described.

Figure 7.6-17 “Replacement contents (Clinch)” screen

When you select the <Replace> button, the

system starts replacing data and displays the

“Replace Component List” screen.

Select “Check” from the

tree view to display the

screen for checking.

Then, open the “Tombstone

Detection” screen on the

right side.

When you select the <Replace> button, the

system starts replacing data and displays the

“Replace Component List” screen.

Select “Clinch” from the tree view

to display the screen for checking.

JaNets Instruction Manual 7. Program Editor

7-129

(14) Replacement contents (Dispense)

Specify data of the adhesive dispensing conditions to be replaced on the following screen.

Figure 7.6-18 “Replacement contents (Dispense)” screen

(15) “Replace Component List” screen

When you select the <Replace> button on the screen for setting the replacement conditions

or on the “Replacement contents” screen, the system displays the list of component data to

be replaced that is extracted under the conditions set on the screen for setting the replace-

ment conditions.

Figure 7.6-19 “Replace Component List” screen

Replace: Starts replacing component data on the line se-

lected at the present.

All Replace: Starts replacing all displayed component data.

Close: Stops replacement of component data.

This check box specifies whether to ask you if

you want to replace data by displaying the “Re-

placement Inquiry” screen after you click the

<Replace> button or the <All Replace> button.

Select “Dispense” from the

tree view to display the

screen on the right side.

If there is no adhesive data,

the menu item “Dispense” is

not displayed on the tree

view.