CP40 service manual - 第107页
2. Conveyor (CP-40) J9800393 Conveyor I/F Board Ass'y J2102038 Chip Cover Side 2 3 1) Using Teaching Box, Move Head to the Rear. 2) Turn Conveyor Width Adjusting Handle to the Left- hand Side to Widen Conveyor Width…
2. Conveyor
(CP-40)
NO Symptom Possible Cause Error Code Action
Instructio
n
1
B/U Table
Malfunction
When Back Up Down, Adjustment is not
Made Properly.
Adjust Cushion.
2 But Up Sensor does not Sense anything. Adjust Position of Sensor.
3
Bad Hole Fixer
Bad Hole Fixer Setting Adjust Hole Fixer Push.
4 Bad Parallelism Tight Fixing Bolt Again.
5
Hole Fixer Malfunction
Adjust Position of Sensor.
6 CheckHoleFixerAir.
7 Adjust Hole Fixer Push.
8
Motor Malfunction
Counter-rotation of Motor Modify Connector Pin.
9 Slow Rotation of Conveyor Motor Replace Conveyor Pack Board.
10 OUT Conveyor Motor does not Rotate. Modify Conveyor Pack Board No.1&2 Wiring.
11 Largest PCB does not Reach 400.
Modify Conveyor Wiring in Rear Feeder
Part.
4-3-2
12 Place Conveyor Motor does not Rotate. Check 24V DC Power.
13
Sensor Malfunction
Wait Sensor Malfunction Adjust Sensitivity of Wait Sensor. 2-3-2
14 Bad PCB Loading Adjust Sensitivity of Wait Sensor. 2-3-2
15 Large Size PCB Driving Error Adjust Place Stopper Speed Con. 2-3-2
16
Bad Feeder Unlock Sensor
Replace Feeder Unlock Sensor. 4-3-3
17 Position Feeder Unlock Sensor Properly. 4-3-3
2-2 Trouble Diagnosis
2. Conveyor
(CP-40)
J9800393
Conveyor I/F Board Ass'y
J2102038
Chip Cover Side 2
3
1) Using Teaching Box, Move Head to the Rear.
2) Turn Conveyor Width Adjusting Handle to the Left-hand Side to Widen Conveyor Width as Wide as Possible.
3) Loosen Seven M3*6 Toras Bolts to Open Chip Cover in Left-hand Side inside Equipment.
4) Disconnect Connector on PCB.
5) Loosen Six Spherical Head Bolts to Disconnect Feeder I/F Board.
6) Replace New PCB and Assemble it according to Reverse Procedures..
2
Version Date WA QA CA Note
00 Nov04 O O O
2-3-1. Conveyor I/F Board Replacement
2. Conveyor
(CP-40)
2-3-2. Conveyor I/F Board Cable Check
INPUT SENSOR
PLACE STOPPER
HOLE
FIXER
OUTPUT SENSOR
PLACE SENSOR
WAIT SENSOR
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
J9800393
Conveyor I/F Board Ass'y
19 Up
20 Down
J3212025A
SENSOR (Former J1301569)
CN29 CV17-1
CN30 CV18-1
CN31 CV19-1
CN32 CV20-1
Version Date WA QA CA Note
00 Nov04 O O O