TS566R-UserGuide - 第13页

13 2. Touch the “Time Reset” icon to set timer to zero 3. Press an d hold down the foot switch, the spray time will be accumulated 4. Release the foot switch when the desired amount of fluid has sprayed 5. Touch the “Tim…

Alternately, touch and hold the Run icon on the display to activate the

purge cycle.

5.2.5 Automatic Spray Cycle Setting

1. Touch the “Timed” mode icon to set the spray cycle time.

The icon will turn to green color.

2. Touch the “Spray” icon to enter the setup screen

3. Touch the Up and Down arrows to set the desired spray time

Note: The minimum activation is 0.008 second

4. Press the Check Mark icon to save and exit

5. Press the foot switch to activate the “Timed” spray cycle.

Alternately, touch the Run icon on the display to activate the “Timed”

spray cycle

Note: The unit has an “Interrupt” mode feature. In this mode, the

“Timed” spray cycle can be disrupted if the foot switch is released and

resumed when the foot switch is depressed again.

6. Touch the “Interrupt” icon to activate “Interrupt” mode. The icon will

turn to green color

5.2.6 Teach Mode Setting

In the teach mode, the spray time will be accumulated as long as the foot

switch is depressed. This is helpful in determining the required spray

time when the dispense output is known.

1. Touch the “Teach” icon to enter the teach mode

2. Touch the “Time Reset” icon to set timer to zero

3. Press and hold down the foot switch, the spray time will be accumulated

4. Release the foot switch when the desired amount of fluid has sprayed

5. Touch the “Timed” icon to transfer the accumulated spray time to “Timed”

mode

6. The unit is now set to repeat this “Timed” cycle

5.3 Stored Program in Memory Cell

The unit has 50 memory cells to store all parameters. The controller can activate

all memory cells in sequence mode.

5.3.1 To store dispense parameters

1. Touch the forward or backward arrow to select the desired memory cell.

2. Enter all the desired parameters then touch the “Save”

icon to save the data

5.3.2 To run in Continuous Mode

The controller can be setup to repeat the run continuously.

1. Touch the Setup icon to enter the setup screen

2. Touch the “Run Method” icon

3. Enter the delay time (ex. 5000 ms)

NOTE: The minimum delay time is 15ms

4. Touch the “Continuous Run” icon

5. Touch the Check Mark icon to save

6. Touch the X icon to exit

The screen will look similarly to the screen below:

Note: If the controller is set to activate memory cell 1 and the delay time is

set at 5000 ms, the controller will activate memory 1 continuously with

5000 ms delay between each activation.