00198377-01_SM_JTF-ML2_en - 第74页
4 Conveyor Mechanics 4.2 Removing the Conveyor Driver Unit and its Parts as Preparatory Steps 74 Service Manual SIPLACE JTF-ML2 08/2017 Installation ► Follow the removal instructions in reverse order for installation. Al…
4 Conveyor Mechanics
4.2 Removing the Conveyor Driver Unit and its Parts as Preparatory Steps
Service Manual SIPLACE JTF-ML2 08/2017 73
► Remove the Left rail cpl.[ 03146884-xx] (1).
Left rail cpl.[ 03146884-xx]
NOTICE
Cables
Mark the two cables before removal to avoid mix up during assembly.
► Loosen socket head shoulder screw M4x5x16
[03145465-xx] (1) to right to loosen the tension
on the Toothed belt 10+-0.1 S2M/726 [03130743-
xx] (2).
► Remove the Toothed belt 10+-0.1 S2M/726
[03130743-xx] (2).
Continue with:
4.3 "Replacing the Conveyor Roller Assembly" [}82]
4.2.1 "Replacing the Driving Pulley" [}75]
4.2.2 "Replacing the BLDC Motor and Conveyor Drive Pulley" [}76]
Replacing the Single Disk Flexible Coupling
4 Conveyor Mechanics
4.2 Removing the Conveyor Driver Unit and its Parts as Preparatory Steps
74 Service Manual SIPLACE JTF-ML2 08/2017
Installation
► Follow the removal instructions in reverse order for installation. Also observe the following in-
structions:
► After you put back the Toothed belt 10+-0.1
S2M/726 [03130743-xx], move and fasten the
Roller f. adjust [03129009-xx] with the loosened
socket head shoulder screw M4x5x16
[03145465-xx] (1) to heighten the tension on the
belt.
► Test the belt tension (1) with a belt tension meas-
uring device.(2).
► Repeat the process until the belt tension is at 70
+/-5 Hz.
4 Conveyor Mechanics
4.2 Removing the Conveyor Driver Unit and its Parts as Preparatory Steps
Service Manual SIPLACE JTF-ML2 08/2017 75
4.2.1 Replacing the Driving Pulley
Parts, Equipment and Tools
●
Standard tools
●
Driving pulley S2MZ26 [03128931-xx]
Removal
► Remove the conveyor (See Removing SIPLACE JTF-ML2 Conveyor from Machine).
► Follow the instructions to get to Conveyor driver unit [03132255--xx] parts ( See 4.2 "Remov-
ing the Conveyor Driver Unit and its Parts as Preparatory Steps" [}72]).
► Remove the screw ISO 4762 - M 3 x 6-A2-70
[03042541-xx] (1) while holding the conveyor
shaft (3) with a screw wrench.
► Remove the Driving pulley S2MZ26 [03128931-
xx] (2).
Driving pulley S2MZ26 [03128931-xx] removed.
Installation
► Follow the removal instructions in reverse order for installation.