00198377-01_SM_JTF-ML2_en - 第96页
4 Conveyor Mechanics 4.7 Replacing the Pusher Unit and Parts 96 Service Manual SIPLACE JTF-ML2 08/2017 ► Remove the Pusher motor heat transfer block A [03148008-xx] (3) ► Disconnect the connector (1) . ► Disconnect the c…
4 Conveyor Mechanics
4.7 Replacing the Pusher Unit and Parts
Service Manual SIPLACE JTF-ML2 08/2017 95
4.7 Replacing the Pusher Unit and Parts
Parts, Equipment and Tools
●
Standard tools
●
Pusher unit complete [03147372-xx]
Removal
► Switch off the machine, disconnect it from the power supply and secure it to prevent
unauthorized reactivation. Observe the instructions in section 1.2 "Preparatory Work..." [}11].
► Remove the conveyor (See Removing SIPLACE JTF-ML2 Conveyor from Machine).
► Remove the four screws DIN EN ISO 7380-M3 x
5-A2-70 [03045193-xx] (1).
► Remove the Conveyor motor cover [03145679-
xx] (2).
► Remove the two screws ISO 4762 - M 4 x 8-
A2-70 [03042551-xx] (1).
4 Conveyor Mechanics
4.7 Replacing the Pusher Unit and Parts
96 Service Manual SIPLACE JTF-ML2 08/2017
► Remove the Pusher motor heat transfer block A
[03148008-xx] (3)
► Disconnect the connector (1).
► Disconnect the connectors (2).
NOTICE
Heat transfer interface sheet
Take note of the heat transfer interface, do not tear the material (heat transfer interface)
Make sure to push tight against the motor during installation.
► Remove the two screws ISO 4762 - M 4 x 8-
A2-70 [03042551-xx] (1).
► Remove the Pusher unit cpl. [03147372-xx]
4 Conveyor Mechanics
4.7 Replacing the Pusher Unit and Parts
Service Manual SIPLACE JTF-ML2 08/2017 97
Installation
► Follow the removal instructions in reverse order for installation.
► Check the two dowels (1) before assembling
back.
4.7.1 Replacing the Toothed Belt Synchroflex
Parts, Equipment and Tools
●
Standard tools
●
Toothed belt synchroflex 6+-0.1 S3M/459 [03146204-xx]
Removal
► Switch off the machine, disconnect it from the power supply and secure it to prevent
unauthorized reactivation. Observe the instructions in section 1.2 "Preparatory Work..." [}11].
► Remove the conveyor (see 2.1.1 "Removing Conveyor from Machine" [}17]).
► Remove Pusher unit cpl. as in Chapter Replacing the Pusher unit cpl.
► Remove the screw ISO 4762 - M 3 x 6-A2-70
[03042541-xx] (1).
► Remove the Pusher vertical guide rail cpl.
[03147453-xx] (2).
Pusher vertical guide rail cpl. [03147453-xx]