00198354-01_AI_Loc2_Fixed_Table_en - 第12页
1 Introduction 1.4 Staff Qualifications and Training Assembly Instructions E by SIPLACE Location 2 Fixed Table 04/2017 12
Assembly Instructions E by SIPLACE
Location 2 Fixed Table 04/2017
1 Introduction
1.3 Other Instructions
9
► Release of stored energy:
Stored energy in the compressed air supply or electrical energy in electrolytic capacitors must
be released by appropriate means.
ð After switching off the machine, wait until the voltages and the compressed air have dis-
charged, so that work can be performed without any risk.
► Testing the lock out:
The lock can be easily tested by pressing the START button.
► The following steps must be taken to restore the machine to operation.
► Check the working area. Authorized employees should remove all of their tools and reinstall
all safety features.
► Notify all affected employees.
► Before removing even one lock or tag, inform all workers in the affected area that the machine
is going to be restarted.
► Remove locks/tags
► Every authorized employee must remove his own lock and shut it away.
► Turn the machine on. Make sure that authorized staff check the equipment in operation to en-
sure that repairs were performed correctly
Testing
Service personnel may test circuits by energizing them briefly without suspending the Lock Out /
Tag Out Procedure. This may only be done when no other work is being performed by any other
person on the equipment being tested.
It is extremely important that all remote START switches be tagged with the "Do Not Operate" tag
to prevent inadvertent operation of the equipment during these periods.
Responsibilities
●
It shall be the responsibility of the maintenance and service personnel to make sure this pro-
cedure is adhered to.
●
It shall be the responsibility of the maintenance and service personnel's immediate supervisor
to instruct his personnel on this procedure.
●
It shall be the responsibility of the Safety Officer with assistance from the Safety Committee,
Health Service Department, and the various managers and vice-presidents to administer the
Lock Out / Tag Out Procedure.
1.3 Other Instructions
1.3.1 Environmentally-Friendly Disposal of Materials and Components
Our products are manufactured using only materials and parts that can be easily separated and
disposed of in an environmentally-friendly way.
NOTICE
Observe the applicable regulations
The company operating the system has sole responsibility for the proper, environmentally-
friendly disposal of machines, working materials, consumables and wear parts.
► Please observe your national statutory provisions for waste disposal and environ-
mental protection.
1.3.2 Use of Original SIPLACE Accessories and Spare Parts
Only use original spare parts and authorized accessories. The use of other parts will affect safety
and will invalidate the liability for any consequential damage.
1 Introduction
1.4 Staff Qualifications and Training
Assembly Instructions E by SIPLACE
Location 2 Fixed Table 04/2017
12
Assembly Instructions E by SIPLACE
Location 2 Fixed Table 04/2017
2 Installation
2.2 Preparatory Work
15
► Remove the four covers from location 2.
► Remove the side cover and cover from location 1 as shown.