00193897-0302_AI_MTC2 BE_DE EN - 第136页

Assembly instructions MTC2 and Component docking unit on SIPLACE HF and X-se ries Edition 07/2009 134 : Check for horizont al alignment on the MTC with a spirit level. 2 Fig. 2.12.2 T op view: MTC alignment 2 : Secure th…

100%1 / 146
Assembly instructions MTC2 and Component docking unit on SIPLACE HF and X-series
Edition 07/2009
133
2.12 Docking of the MTC2
: Check the height of the MTC2.
It must have the same height as the place
ment machine.
2
The height is indicated in the small window below the cover under the door of tower 1
(830 / 900 / 930 / 950 ± 15 mm).
2
: If it does not have the same height as the placement machine, adjust the MTC to the machine
height and then dock it to the machine.
2
For further information, see operating instructions of MTC2:
00193634- Operating instructions SIPLACE MTC2
00193635- User Manual SIPLACE MTC2 2
2
The MTC must not be higher than the clamping edges of the PCB conveyor. 2
2
2
Fig. 2.12.1 The height of the MTC must be adjusted to the PCB conveyor.
2
2
2
Assembly instructions MTC2 and Component docking unit on SIPLACE HF and X-series
Edition 07/2009
134
: Check for horizontal alignment on the MTC with a spirit level.
2
Fig. 2.12.2 Top view: MTC alignment
2
: Secure the MTC in the machine.
2
2
2
2
Assembly instructions MTC2 and Component docking unit on SIPLACE HF and X-series
Edition 07/2009
135
2.13 Using the MTC with the CPP placement head
: Read the "Head Reconfiguration CPP" assembly instructions, if necessary (item no.:
00196428-xx).
2
– With the MTC, the placement head must only be fitted in the top position. The installation height
is monitored during the head reference run.
– In software version 702, the CPP head is not appro
ved for a 2-gantry placement area with
MTC. In this case there is no nozzle changer available at the location with MTC.
– Crash risk: Wh
en the CPP head is used with the MTC, the travel range must also be re-
stricted. You should therefore fit 2x the extens
ion for the Y axis stop (item no.: 03075963-01
"Adaptation, Y axis stop, MTC“). These are included in the package as a precautionary mea-
sure.
Standard stop
Stop withMTC