00193897-0302_AI_MTC2 BE_DE EN - 第83页

00377312-xx Retrofit kit interface comp onent trolley HF up to A001 left for location 1/3 00377313-xx Retrofit kit interface comp onent trolley HF up to A001 ri ght for location 2/4 Assembly instructions MTC2 and Compone…

100%1 / 146
Assembly instructions MTC2 and Component docking unit on SIPLACE HF and X-series
Edition 07/2009
80
2.5 Montage component docking unit
2.5.1 Preparatory work
: Shutdown the computer and turn it off.
: Switch off the placement machine at the main switch.
: Open the protective cover.
: Disconnect the machine from the power supply and
lock to prevent reconnection.
: Open and remove the cover over the compressed-air supply or power supply and place it out-
side the working area.
: If necessary, the machine cover (depending on location right or left) must be removed. For fur-
ther information, see Chapter 2.6.2 ”Assembly of machine protection” or page - 102 "Mount
parts from retrofit kit".
2.6 Installation of component docking unit for S-tape
feeders on a SIPLACE HF (Series No. up to A001)
The machine should now be as follows: 2
2
Fig. 2.6.1 For installation in prepared machine
00377312-xx
Retrofit kit interface comp
onent trolley HF
up to A001 left for location 1/3
00377313-xx
Retrofit kit interface comp
onent trolley HF
up to A001 right for location 2/4
Assembly instructions MTC2 and Component docking unit on SIPLACE HF and X-series
Edition 07/2009
81
2
Fig. 2.6.2 For installation in prepared machine (inside)
2
2
2
Prior to installation of the component docking unit, ensure that the tape cutter control PCB is
coded for the correct location (see jumper marking on control PCB). For further information, see
imprint on tape cutter control PCB. 2
2
2
2
2
2
2
2
Assembly instructions MTC2 and Component docking unit on SIPLACE HF and X-series
Edition 07/2009
82
: Mount the fit-up aid (2) on the fasteners (1) provided on the component docking unit.
: Attach the lifting device to the eye (3) of the fit-
up aid (2).
2
Legend 2
1. Fixing
2. Fit-up aid f. carriage or entering /X-S (03015976-)
3. Eye
2
Heavy machine component:
The component docking unit is very heavy. For lifting purposes, the fit-up aid and suitable lifting
equipme
nt must be used (hand crane, etc.). 2
: Suitable gloves must be worn for lifting the component docking unit in position.
Gloves reduce the risk of cuts caused by the bla
de of the tape cutter.
2
2
Ensure that the cables and hoses are not damaged. 2
2
: Remove the fit-up aid.
2
2
2
2