00197042-04_SM_X-Serie-S_Customer_EN - 第301页
7 Conveyor 7.10 Conveyor sides Service Manual SIPLACE X-Serie S 06/2019 301 7.10.3 Calibrating the Conveyor Rails NOTICE This chapter is valid for machines with dual conveyor (DC) only. Fig.380: Service menu ► Switch ov…
7 Conveyor
7.10 Conveyor sides
300 Service Manual SIPLACE X-Serie S 06/2019
Fig.379: Spacer (example of SX1/SX2 shown)
1 View from the side 2 View from above
3 Spacer piece (here: metal platelet) 4 Adjustment unit
5 Frame 6 Warehouse
► Position the adjustment units so that these lie flush against the lifting table guides between the
frame and the adjustment unit.
► Tighten the fastening screw of the movable idler pulley.
► Check the parallelism of the adjustment units again and correct again if necessary.
► If the conveyor side clamps have loosened, fix these again.
► Set the tension of the toothed belt.
7.5.2.1 "Setting the belt tension (width adjustment)" [}228]
► Calibrate the width adjustment motor.
(The calibration is identical for the lifting table motor.)
► Use the software to move the fixed conveyor side. This ensures that the fixed conveyor side is
parallel to the flexible sides. Readjust the fixed conveyor side to its original value after that.
7 Conveyor
7.10 Conveyor sides
Service Manual SIPLACE X-Serie S 06/2019 301
7.10.3 Calibrating the Conveyor Rails
NOTICE
This chapter is valid for machines with dual conveyor (DC) only.
Fig.380: Service menu
► Switch over to the activity level "Ser-
vice (customer)" (or better still).
► Switch over to the service menu
.
► Select "Conveyor configuration".
Fig.381: Setting the conveyor side
► Select "Set options for conveyor fixed
rail"
.
► Use the
button to select the
required conveyor lane.
► Set the conveyor position.
The fixed sides will later have their original
positions again.
Fig.382: Service menu
► Switch over to the service menu
.
► Select "Single calibration".
7 Conveyor
7.10 Conveyor sides
302 Service Manual SIPLACE X-Serie S 06/2019
Fig.383: Calibrating the conveyor sides
► Click on this button:
.
► Select "Calibrate conveyor sides".
7.10.4 Fixed Side Right/Left
NOTICE
No conversion possible
The SIPLACE X-Series S single conveyor is available in the variants "fixed side right" and
"fixed side left".
Conversion from a fixed side right to a fixed side left or vice versa is not possible. In this
case, the conveyor must be replaced by your SIPLACE service team.