Setup Center Patch and Extensions - 第5页
SIPLACE 1 Installation manual SetupCenter Patch and Extensions (00169117) 05/2006 Edition 5 1 Inst allation manual SetupCenter Patch and Extensions (001691 17) 1.1 General T wo new functions wher e added to the Setup Cen…
Installation manual SetupCenter Patch and Extensions (00169117) SIPLACE
05/2006 Edition
4
SIPLACE 1 Installation manual SetupCenter Patch and Extensions (00169117)
05/2006 Edition
5
1 Installation manual
SetupCenter Patch and Extensions
(00169117)
1.1 General
Two new functions where added to the Setup Center 2.1 SP1: 1
– Activation with Barcode.The Barcode Assistant of Setup Center can now print barcodes for
"Activate Track" for each location, similar to the existing Tableverification and Refill barcodes.
Scanning of a reel after activating a track is now required
– A new barcode type has been added "DoubleCheckWithComponent". With this, it is possible
to verify the component against another source, for example a setup printout with barcodes for
the components. The “DoubleCheckWithComponent” barcode is configured the same way as
the existing Barcode types. Example: a reel has the barcodes "UniqueId", "Component" and
"OriginalQuantity". These are configured in the settings dialog as in Setup Center RF 2.1. Now
a new barcode with the type "DoubleScan" is added to these. The operator must first scan all
barcodes on the reel, then the component on the setup printout.
1.2 Scope of delivery
1.2.1 Software components
1009694 Setup Center Patch and Extensions: 1
– CD (with Setup Center 2.1 SP1)
– Documentation
– General terms and conditions of SIEMENS AG.
1.2.2 Languages
German and English are supported. 1
1.3 Requirements
SIPLACE Pro 3.1 SP1 interface installed on the same computer. 1
1 Installation manual SetupCenter Patch and Extensions (00169117) SIPLACE
05/2006 Edition
6
1.4 Safety instructions
WARNING
The safety instructions from the “Operational safety” chapter of the user manual and servicing in-
structions take precedence over these instructions. 1
The SIPLACE placement machines are supplied with mains voltage.
Consequently parts of these systems carry dangerous voltages! This voltage is present at certain
modules inside the machine base, even when the machine is switched off at the main power
switch.
Incorrect handling of the placement machine or touching live parts of the machine can result in
death or severe injury, and considerable damage to equipment.
BEFORE starting any work, shut down the operating system correctly, then switch the machine
OFF at the main power switch and disconnect from the main power supply. In addition, the com-
pressed air supply must be switched off at the compressed air unit's main valve in the machine
base and vented by actuating the needle valve on the compressed air unit.
There is DANGER for heart pacemaker wearers in the vicinity of the linear motors, as described
in detail in the "Special safety instructions for working in the vicinity of strong magnetic fields"
section of the user manual and service manual.
Always follow the accident prevention regulations, DIN or other standards and special safety
rules applicable in your country.
Pay attention to the information concerning residual voltages in the Operational Safety chapter.
Follow the ESD regulations as described in the operational safety section of the operating
instructions.
During the retrofit, always secure the machine to prevent access by other people and to prevent
it being switched on again. The procedure is described in the “Locking the machine…” section of
the user manual.
Working with the SITEST program further increases the risk of accident.
The SITEST program must only be used by authorized and trained personnel.
1
1
1