00194081-01 - 第139页
User Manual SIPLAC E CF 6 Component han dling Software Version SR.408.xx 03/2006 US Edition 6.2 Technical data for the S feeder modules 139 6.2 T echn ical da t a fo r the S feeder modules The foll owing pages c ontain p…
6 Component handling User Manual SIPLACE CF
6.1 Feeder modules Software Version SR.408.xx 03/2006 US Edition
138
6.1.1 Safety instructions for processing capacitors based on powdered metal
There is a risk associated with processing capacitors based on powdered metal (e.g. tantalum).
The risk is that
– an exothermic reaction, i.e. a sudden build-up of heat, may occur, if these components are
damaged. If the ambient conditions are unfavorable, and depending on the capacitance, this
build-up of heat can cause damage.
– This effect can occur when these components are cut.
Please contact your suppliers to clarify whether the components that you handle are affected.
In extremely rare cases, this risk can occur in the tape cutter of SIPLACE machines, with the re-
mote possibility of causing a smoldering fire in the waste tape.
The ambient conditions are unfavorable if:
(1) The components remain on the tape while the set tape cycle is checked (since the operator
can cycle the feeder module onward without removing components during this check).
(2) The components remain on the tape, e.g. due to a tear in the cover foil.
(3) The components remain on the tape, and the components or tape do not conform to the
specification, thus increasing the pick-up error rate.
Please follow the instructions given below to minimize the risk when placing capacitors based on
powdered metal.
(1) If the component tape is cycled onward manually, the operator must remove any components
remaining in the tape pocket.
(2) If the cover foil tears, the operator must remove any components remaining on the tape.
(3) The waste tape container must be emptied regularly (recommended interval: every hour)
6
WARNING
To avoid the risk, it is essential to use only feeder modules
that have been approved for placing such components,
namely:
for model C/D item no.: 00141118-01
for model E item no.: 00141117-01 6
6
The feeder modules are labeled
as shown below:
6
User Manual SIPLACE CF 6 Component handling
Software Version SR.408.xx 03/2006 US Edition 6.2 Technical data for the S feeder modules
139
6.2 Technical data for the S feeder modules
The following pages contain pictures of all the S feeder modules, the technical data and the op-
tions for setting up the feeder modules on the machine.
6.2.1 Tape feeder module 8 mm S II
6
Fig. 6.2 - 1 Tape feeder module 8 mm S II
Item no. 00141096-xx 6
Width 30.6 mm 6
Tracks per feeder module 2 6
Feeder module locations filled 1 6
Maximum number of feeder modules 2 x 20 6
Stock of components for 7" reels approx. 4,000 6
Conveyor increment 2mm / 4mm 6
6 Component handling User Manual SIPLACE CF
6.2 Technical data for the S feeder modules Software Version SR.408.xx 03/2006 US Edition
140
6.2.2 Tape feeder module 3 x 8 mm S
Fig. 6.2 - 2 Tape feeder module 3 x 8 mm S
Item no. 00141098-xx 6
Width 30.6 mm 6
Tracks per feeder module 3 6
Feeder module locations filled 1 6
Maximum number of feeder modules 2 x 20 6
Stock of components for 7" reels approx. 4,000 to 10,000 6
Conveyor increment 2mm / 4mm 6