DuraBlue II Customer Product Manual - 第40页
Installation 3-12 Part 1126931_01 2018 Nordson Corporation Connect Applicators Observe the following guidelines: DuraBlue II melters with 120‐ohm nickel sensors support all Nordson T‐style applicators. DuraBlue‐II me…
Installation
3-12
Part 1126931_01
2018 Nordson Corporation
Connect Applicators
Observe the following guidelines:
DuraBlue II melters with 120‐ohm nickel sensors support all Nordson
T‐style applicators. DuraBlue‐II melters with 100‐ohm platinum sensors
support all Nordson M‐style applicators.
For information about choosing the most appropriate Nordson hot melt
applicator for your manufacturing process, refer to the latest edition of
Nordson's hot melt dispensing equipment Replacement Parts Catalog or
contact your Nordson representative. Refer to Appendix A, Calculating
Melter Power Requirements, for information about how to calculate the
power required by Nordson hot melt applicators.
Refer to the user's guide that is shipped with each applicator for
information about installing the applicator and connecting a hose to the
applicator.
NOTE: DuraBlue II adhesive melters are shipped with a 0.2 mm hot melt
filter installed in the manifold. Order the appropriate applicator nozzle based
on this filter mesh size.
Installation
3-13
Part 1126931_01
2018 Nordson Corporation
Setting Up the Melter
After physically installing the melter, it must be set up to support your
manufacturing process. Melter setup consists of enabling or making changes
to factory‐set operating parameters that affect the use and function of the
melter. The operating temperature (set‐point) of the tank and each hose and
applicator is also established during melter setup.
The melter is shipped from the factory with the most commonly used
operating parameters already set up. The factory setup can be modified at
any time to suit your manufacturing process.
Quick Setup
Table 3‐2 describes the most commonly used operating parameters and their
factory settings. Review the table to determine if the factory settings for each
parameter will support your manufacturing process. If the default values for
each of these operating parameters are appropriate for your manufacturing
process, then no melter setup is required. Go directly to Set‐point
Temperature of the Tank, Hoses, and Applicators later in this section to
complete the installation process.
If you need to make changes to the factory setup or if you want to learn about
other operating parameters, go to the next part in this section, Operating
Parameters.