OM-1833-001w_SL - 第110页
Remedy : Remove any chip component or foreign substance such as debris attached on the suppressor and completely clean the suppressor . Foreign Substance If the taping component is mounted with any foreign substance atta…
9. Troubleshooting
The main troubleshooting during the tape feeder operation is described here.
In the event of trouble, con rm in which section the trouble is caused and set it
right.
9.1 Component Pick-up Error
Remedy
: Unload the tape and process the tape end correctly, and then load it.
Cut the tape at the position to the left end
of the next sprocket hole as shown in the
above figure.
NG
OK
If the component center is not aligned with the pick-up position, then the pick-up cannot
proceed correctly.
Refer to "2.4 Tape End Processing Procedure" for the tape end processing procedure.
Cause : Pick-up position is not correct (pitch deviated)
In the tape end processing in the tape loading operation, if the tape is not cut at the cor-
rect position, the feeding position pitch would be deviated.
Remedy
: Adjust the pick-up position by using the feeder adjusting jig JG-0209
(Purchase separately).
Pick-up Position
If the component center is not aligned with the pick-up position, then the pick-up cannot
proceed correctly.
Cause : Error in Pick-up Position
9. Troubleshooting
Reference
Notice
Notice
1504-001
OM-1833
9-1
Remedy
: Remove any chip component or foreign substance such as debris attached on the
suppressor and completely clean the suppressor.
Foreign Substance
If the taping component is mounted with any foreign substance attached, the suppressor
might be deformed or a pick-up error occur.
Therefore, clean it.
Cause : A chip component is attached to the inside cover tape processing unit
and moves irregularly.
Remedy
: Unload the tape and process the tape end correctly, and then load it.
NG
OK
Perform the end processing before the tape loading.
Refer to "2.4 Tape End Processing Procedure" for the tape end processing procedure.
Cause : Cover Tape Processing Unit Malfunction
•
In the case that the tape end processing is not correct, a malfunction might be
caused in the tape loading.
•
I
n the case that there are any wrinkles on the tape, a malfunction might occur.
•
In the case the succeeding tape thickness is not even, a malfunction might
occur.
9.1 Component Pick-up Error
Reference
Notice
Remedy
: Clean the machine’s vacuum nozzle as described in the SIGMA-G5/G5S/F8 instruction
manual “Section 4: Maintenance and Troubleshooting”.
If the factory is dusty or if paper taping component is often used, then the vacuum nozzle and vacuum
nozzle lter can easily become dirty.
Keep them clean.
Cause : Dirty Vacuum Nozzle
Clogged Vacuum Nozzle Hole
Dirty Vacuum Nozzle Filter
Note
1504-001
OM-1833
9-2
1504-001
9.2 Tape Feeder not correctly locked
Remedy
: Remove any chip component or foreign substance such as debris attached on the
feeder base and completely clean the feeder base.
If the tape feeder is used while it has not been locked, it might cause damage to the machine or pick-
up error.
Attach the tape feeder securely to the feeder base.
Cause : Chip component or foreign substances including debris have been
attached onto the feeder base.
Note
9.2 Tape Feeder not correctly locked
OM-1833
9-3