OM-1833-001w_SL - 第29页
• T aping Components should not have any component being adhered to the carrier tape or the cover tape. Paper tape Embosses tape Fig. A13 * T aping Components like the followings can not be dealed with the SL feeders. Th…
1504-001
1.3 Taping Specications
•
The top surface of any component in Taping Components should be lower than
the top surface of the carrier tape keeping proper pocket clearance of the carrier
tape.
MIN. 40μm
MIN. 40μm
Paper tape Embossed tape
Fig. A11
* Taping Components like the followings can not be dealed with the SL feeders.
The component is projected out from
the carrier tape.
(The paragraphs 3.1/3.2 of IEC 60286-3
(JIS C0806-3) are not satisfied.)
Paper tape Embossed tape
Cover tape
Carrier tape
Paper tape
Embossed tape
Cover tape
Carrier tape
The rising like a bump is adhered to
the electrode.
→
So, the component is projected
out from the carrier tape.
(The paragraphs 3.1/3.2 of IEC 60286-3
(JIS C0806-3) are not satisfied.)
Fig. A12
OM-1833
1-8
•
Taping Components should not have any component being adhered to the
carrier tape or the cover tape.
Paper tape Embosses tape
Fig. A13
* Taping Components like the followings can not be dealed with the SL feeders.
The component is being
adhered to the cover tape.
(The paragraph 5.2.3 of IEC 60286-3
(JIS C0806-3) is not satisfied.)
Paper tape Embossed tape
Cover tape
Carrier tape
The component is being adhered
to the side wall of the carrier tape pocket.
The paragraph 5.2.3 of IEC 60286-3
(JIS C0806-3) is not satisfied.)
Paper tape Embossed tape
Cover tape
Carrier tape
Fig. A14
•
The cover tape of Taping Components should not concave downward into
pockets, and it should be fused on the carrier tape in at manner.
Paper tape Embosses tape
Fig. A15
1.3 Taping Specications
OM-1833
1-9
* Taping Components like the followings can not be dealed with the SL feeders.
The cover tape is
concaved downward.
Embossed tape
Cover tape
Carrier tape
Fig. A16
The cover tape is concaved
downward around the pocket.
Enlarge
Fig. A17
•
For the Taping Components, the top surface of the carrier tape should be at
and no dip in the center of the surface.
And, in case of that each distance between pockets is narrow, the top surface
of the carrier tape should be higher than any components stored in the taping
carrier.
* Taping Components like the followings can not be dealed with the SL feeders.
Pocket
Fused bands of
cover tape
Embossed tape
The top surface of the carrier tape is not flat,
and each area between pockes is dipped downward.
Fig. A18
Cover tape
Embossed tape
Each distance between pockets is narrow, and the top surface of
the carrier tape is not higher than the top surface of stored
components in relation to the taper angle of forming embossed
pocket. (No clearance)
Fig. A19
1.3 Taping Specications
OM-1833
1-10