OM-1833-001w_SL - 第72页

The lane where a component shortage has occurred is notied with the dot display . When the succeeding component reload tape has not been setup after the tape end has been judged and the remaining tape forcible feeder op…

100%1 / 122
[Detection Description] Time Over Current Detection Error
The current detector is abnormal.
System Error
An error occurs in the servo amplier inner program.
Ab System Error
[Detection Description] Position Deviation Too Large
The position deviation inside the amplier is too large.
Position Deviation Too Large when servo is turned ON
When the servo motor is turned on, the position deviation inside the
amplier is too large.
Ad Position Deviation Too Large
[Detection Description] Run-away has been detected.
The servo-motor has run away.
Ac Run-away Detection Error
[Detection Description] Encoder signal amplitude error or A/D data error
The amplitude of the encoder signal was small or there was A/D converter
error.
Encoder acceleration error
Encoder position data was vanished.
Encoder adjustment operation error nishes
During encoder adjustment, the operation was nished due to an error.
Encoder adjustment value detection error
The detected encoder adjustment value was abnormal.
A8 Encoder Error
1504-001
4.3 Error Code, Component Shortage Notication
OM-1833
4-15
The lane where a component shortage has occurred is notied with the dot display .
When the succeeding component reload tape has not been setup after the tape end has been judged and
the remaining tape forcible feeder operation has been completed, this component shortage indication
is displayed to notify the operator to reload the component.
Component Shortage Notication
Repeated
4.3.3 Component Shortage Notication
1504-001
4.3 Error Code, Component Shortage Notication
OM-1833
4-16
1504-001
5. Maintenance
5.1 Precautions before Maintenance
This describes the check, cleaning, and adjustment for tape feeders operating in
good conditions.
A full and periodical maintenance of the tape feeder is recommended.
CAUTION
Only trained persons should perform maintenance,
both carefully and according to the specied
procedures.
5. Maintenance
OM-1833
5-1