Productivity Lift - 第25页
User Manual - Productivity Lift 2 Operating safety Edition 02/2004 2.2 W a rning signals and warnin g and danger symbols on the Productivity Lift 17 2.2.3.2 W arning sticker W 201 in combination with W 203 S ticker pos i…
2 Operating safety User Manual - Productivity Lift
2.2 Warning signals and warning and danger symbols on the Productivity Lift Edition 02/2004
16
2.2.3 Warning and danger symbols on the lift unit
2.2.3.1 Warning sticker W 201
Article-No.: 03009338-01
Sticker position: On the lift unit under the main switch
Amount per machine: 1
Category: WARNING
Fig. 2 - 1 Warning symbol W201, Art-No. 03009338-01
Fig. 2 - 2 Service door: Warning sticker under the main switch
SAFE OPERATION OF THE MACHINE
Knowledge of and compliance with the user manual and the
safety instructions is a requirement for the safe operation of the
machine and safe intervention in the lift area.
Non-compliance can lead to severe injury to death!
User Manual - Productivity Lift 2 Operating safety
Edition 02/2004 2.2 Warning signals and warning and danger symbols on the Productivity Lift
17
2.2.3.2 Warning sticker W 201 in combination with W 203
Sticker position: Visible after opening of the service door on the front side of the shuttle
transport.
Amount per machine: Sticker combination 1
Category: WARNING
Fig. 2 - 3 Warning sticker W201 in combination with W 203
SAFE OPERATION OF THE MACHINE
Knowledge of and compliance with the user manual and the safety instructions is a requirement
for the safe operation of the machine and safe intervention into the lift area.
A PCB may ONLY be removed in normal mode and THEN only out of the lift interior and only if
the operator can reach the PCB without putting his arm in above the lower arm or bending his up-
per body. The operator may not reach from the lift interior through to the SPLC, even if he/she
wishes to free a jammed PCB from the SPLC.
The service engineer or a suitably qualified person must be commissioned for all intervention in
the machine which exceeds the scope of the normal mode as described here. BEFORE he/she
begins the work, the service engineer or the suitably qualified person must fit the transport locks
according to the instructions in this user manual (see section 2.5 “Fitting the transport locks”), to
secure the height position of the shuttle transport and also of the top conveyor.
Non-compliance with these instructions can lead to severe injury to death!
A
rt.-No. 03009338-01 Art.-No. 03009342-01
in combination with
2 Operating safety User Manual - Productivity Lift
2.2 Warning signals and warning and danger symbols on the Productivity Lift Edition 02/2004
18
The transport locks (U-bars and clamping piece) are necessary safety precautions! The transport
locks must be removed before the lift axle is reactivated and then stored in the lift unit in the des-
ignated position, so that they are always available.
Fig. 2 - 4 Service door: Warning sticker underneath the main switch
Fig. 2 - 5 Service door: Warning sticker underneath the main switch
Transport locks:
U-bars to secure the shut-
tle unit (Fitted onto the pis-
ton rod)
Transport locks:
Clamping piece for secur-
ing the „Top conveyor“
(Fitted against the under-
side of the „Top con-
veyor“).