00196044-05 - sg x und x4i fse_en - 第20页
General FSUSXS - Course Description S tudent Guide (FSE) SI PL ACE X Series and X4I General Edition 01/2009 EN 20 1.2 FSUSXS - Course Description Course typ e: SIPLACE upgrader training for X series Target group: FSE and…
General
SIPLACE on the World Wide Web (WWW)
Student Guide (FSE) SIPLACE X Series and X4I
Edition 01/2009 EN General
19
1 General
1.1 SIPLACE on the World Wide Web (WWW)
X Select either the German or English version.
The different sections contain information about our products, services and contact persons.
In addition, registered customers can access the SIPLACE User Group. Here you can call up special
information about our placement systems e.g.
Technical documentation,
Technical information,
Spare parts lists etc.
Registration for the user group is very simple:
X Select the Register Now User Group button.
X Fill in the registration form and send it off to us.
Soon afterwards, you will receive your access authorization with USER ID and password.
Log into our SIPLACE ®
homepage at http://
www.siplace.com.
General
FSUSXS - Course Description
Student Guide (FSE) SIPLACE X Series and X4I
General Edition 01/2009 EN
20
1.2 FSUSXS - Course Description
Course type: SIPLACE upgrader training for X series
Target group: FSE and internal personnel
Requirements: SIPLACE X series training with SW701
Course duration: 5 days
Course location: SIPLACE training center Munich
Course objective: The course participants should already know the various assemblies in the
SIPLACE X machines, their differences to SIPLACE X4I, plus their general
functions. They should be able to install the SW70x software and use the new
functions. The participants should be able to completely calibrate the
machine. In addition, they should be familiar with the CPP placement head,
its reference run, placement sequences and the various placement modes.
The participants should be able to localize and fix minor errors. They should
also be able to replace spare parts on the placement head professionally,
service the placement head and ensure that the machine is in the correct
state for placement.
Operational Safety
Safety of Operators and Other Persons Safety Instructions
Student Guide (FSE) SIPLACE X Series and X4I
Edition 01/2009 EN Operational Safety
21
2 Operational Safety
See also:
J
14.1.4 Operational Safety [
J
546]
2.1 Safety Instructions
The following safety instructions are only an excerpt from the chapter "Operational Safety" in the
SIPLACE user manual.
2.1.1 Safety of Operators and Other Persons
Machine operators must only carry out work for which they have been adequately trained and with which
they are totally familiar.
2.1.2 Safety of Plant and Equipment
Never make changes, however minor, unless you are totally aware of the effect they will have on the
overall functioning of the system.
The stations must always be set up, retooled and maintained by appropriately trained personnel.
Only use original spare arts and authorized accessories from Siemens AG. The use of other parts
will affect safety and will invalidate the liability for any consequential damage.
Do not make modifications to the safety equipment. Never bridge protective switches or remove
protective devices.
ATTENTION:
Any staff working on the machine must be familiar with the safety instructions in this user manual
and observe these at all times.
WARNING:
The system is electrically driven. When electrical devices are in use, certain parts carry
dangerous voltage levels.
X Switch off at the main switch and disconnect the placement system from the power supply
before carrying out any work on live components.
X Lock the machine.
X There is a risk of death, severe injury and/or considerable damage to equipment if these
instructions are not followed.