00196044-05 - sg x und x4i fse_en - 第546页
MTC2 Overview Oper ational Safety S tudent Guide (FSE) SI PL ACE X Series and X4I MTC2 Edition 01/2009 EN 550 14-15: Information labels above the guides for the fork lift truck 14-16: Information label for the cranking d…
MTC2
Operational Safety Overview
Student Guide (FSE) SIPLACE X Series and X4I
Edition 01/2009 EN MTC2
549
14-11: Warning labels in the refill area (behind the protective doors)
14-12: Information label at the ground terminal
14-13: Warning labels on the motor controller covers (below the enclosure)
14-14: No loads warning by the feed axis
MTC2
Overview Operational Safety
Student Guide (FSE) SIPLACE X Series and X4I
MTC2 Edition 01/2009 EN
550
14-15: Information labels above the guides for the fork lift truck
14-16: Information label for the cranking device
Safety Instructions for Transporting the MTC2
Residual Voltages at the Inverters after Switching the MTC Off
After switching off the MTC2
by pressing the EMERGENCY STOP button,
by opening a protective door or
via the SIPLACE station
it takes about 5 minutes before the intermediate-circuit voltages of the inverters have discharged down
to non-hazardous residual voltages.
When the MTC2 is switched off, the protective contactor combination is still supplied with 24 V AC from
the SIPLACE station.
14-17: Safety Instructions for Transporting the MTC2
The MTC 2 should only be transported over
any significant distance using a suitable pallet
jack or fork lift truck.
If the fork lift or pallet jack has adjustable forks,
the MTC2 must be lifted at the outer edge of
the guide rails.
The forks should only be inserted into the
guides from the side on which tower 1 is
located.
Legend
1. Guides
MTC2
Operational Safety Overview
Student Guide (FSE) SIPLACE X Series and X4I
Edition 01/2009 EN MTC2
551
14.1.4.2 Safety Features
Protective Doors
EMERGENCY STOP button
14-18: Protective Doors
Both towers have a protective door. When you
open the protective door, the tower is powered
down. The following error message appears on
your screen:
Tower x: protective door not
closed
The other tower continues to work until it
completes its cycle. Once the protective door is
closed, the cycle must be restarted.
CAUTION:
Do not open the protective doors of the
MTC2 unless you are informed to do so
on the screen of the station computer
or when the MTC2 has been switched
off.
Legend
1. Protective Doors
2. Recessed handles
14-19: Location of the EMERGENCY STOP button
Legend
1. EMERGENCY STOP button
The EMERGENCY STOP button is a self-latching
combination and designed with bypass protection
according to EN 418. This red, mushroom-shaped
button remains depressed when you press it.
When you press the EMERGENCY STOP button,
the entire line, with SIPLACE station and MTC2, is
immediately stopped. Placement is interrupted
and, once the machine is in working order again,
can be resumed or canceled. Watch out for any
incompletely assembled printed circuit boards.
Pressing the EMERGENCY STOP button opens
the two switching contacts of the safety circuits;
the relevant safety combination is triggered. The
intermediate-circuit voltages (500 V) for the
inverters are disconnected. Both the lifting and
feed axes are deactivated while the logic circuitry
of the inverters continues to be supplied with 24 V
DC. The following error message appears on your
screen:
EMERGENCY STOP operated
will be
shown on the screen.