00198150-02_SM_TX_en - 第308页
14 JEDEC Tray Feeder 14.1 SIPLACE JTF-ML 308 Service Manual SIPLACE TX Series 06/2017 Fig.454: Flat ribbon cable ► Take care not to fold the flat ribbon cable when mounting the cover in the next step. Fig.455: Fitting …
14 JEDEC Tray Feeder
14.1 SIPLACE JTF-ML
Service Manual SIPLACE TX Series 06/2017 307
Installation
Fig.450: Connecting the flat ribbon cable
► Connect the flat ribbon cable to the new EDIF. Be
aware of the correct orientation of the flat ribbon
cable.
Verify that the cable is fully slipped in the con-
nector base and the ribbon cable is parallel to the
connector base.
Close the interlock by folding it back, similar to
connector X3.
Fig.451: Fitting the EDIF
► Fasten the EDIF with two screws(1).
NOTICE!
For a better view, the diagram shows the EDIF
without the control board X adapter.
It is not necessary to remove the control board X
adapter.
.
Fig.452: Connecting X1
► Connect X1.
Fig.453: Connecting the X3
► Connect X3:
Mount the flat ribbon cable into the X3 base.
Check that the connector is fully slipped in the X3
base and the cable runs parallel to the X3 base.
Close the interlock by folding it back.
► Check the correct connector locking by pulling
the flat ribbon cable gently.
14 JEDEC Tray Feeder
14.1 SIPLACE JTF-ML
308 Service Manual SIPLACE TX Series 06/2017
Fig.454: Flat ribbon cable
► Take care not to fold the flat ribbon cable when
mounting the cover in the next step.
Fig.455: Fitting the cover
► Refit the cover.
14.1.6 Sliding Guides
1. 14.1.6.3 "Replacing the Short Guide Slide Bear-
ing, Left [03012425-xx]" [}310]
2. 14.1.6.2 "Replacing the Slide Guides, Right
[03058808Sxx]" [}309]
3. 14.1.6.1 "Replacing the Long Guide Slide Bear-
ing, Left [03003994-xx]" [}309]
14 JEDEC Tray Feeder
14.1 SIPLACE JTF-ML
Service Manual SIPLACE TX Series 06/2017 309
14.1.6.1 Replacing the Long Guide Slide Bearing, Left [03003994-xx]
Parts, equipment and tools
Fig.456: Guide slide bearing
●
Guide slide bearing back L200 [03003994-xx]
Overview
Fig.457: Guide slide bearing on JTF-ML-Adapter
Position of sliding guide
Removal / installation
► For removal and installation please refer to chapter 5.2 of the service manual "X Feeder
Care" [DE:00196601‑xx] [EN:00196602‑xx].
14.1.6.2 Replacing the Slide Guides, Right [03058808Sxx]
Parts, equipment and tools
Fig.458: Sliding guide parts
●
Sliding guide [03058808Sxx]
Overview
Fig.459: Guide slide bearing on JTF-ML-Adapter
Positions of guide slides
These two guide slides are identical.
Removal / installation
► For removal and installation please refer to chapter 5.1 of the service manual "X Feeder
Care" [DE:00196601‑xx] [EN:00196602‑xx].