00194598-01.pdf - 第43页
Ceramic substrate centering SIPLACE S- 27 HM 2 Retrofit instructions: ceramic substrate centering for SIPLACE S-27 HM 12/2004 Edition 43 2.5 Mechanical co nvers ion : Loosen and r emove th e 4 hex agon soc ket he ad scre…

2 Retrofit instructions: ceramic substrate centering for SIPLACE S-27 HM Ceramic substrate centering SIPLACE S-27 HM
12/2004 Edition
42
2.4 Preparatory work
2
The lifting table beds must be / remain lowered so that there is no strain on the terminal blocks.2
2
: Set the PCB conveyor to maximum width.
: Switch the placement machine off at the main switch.
2
: Screw the solenoid valve onto the supporting plate using two screws (see photograph below).
The terminals of the solenoid valve are assigned as follows: 2
2
2
Compressed air outlet
Silencer
Compressed air inlet
Screws

Ceramic substrate centering SIPLACE S-27 HM 2 Retrofit instructions: ceramic substrate centering for SIPLACE S-27 HM
12/2004 Edition
43
2.5 Mechanical conversion
: Loosen and remove the 4 hexagon socket head screws used to fix the lifting table bed to the
lifting table unit.
2
There is a risk of crushing / cuts while lifting out the lifting table beds, particularly between the outer
edges of the lifting table bed and the conveyor modules. 2
2
: Loosen the 4 hexagon socket head screws on the conversion board cover, and remove it.
2
2
2
2
2
2
2
2
2
2
2

2 Retrofit instructions: ceramic substrate centering for SIPLACE S-27 HM Ceramic substrate centering SIPLACE S-27 HM
12/2004 Edition
44
: Disconnect the compressed air line from the non-return valve and remove the valve.
2
: Disconnect the compressed air hose downstream of the elbow to allow you to fit the non-return
valve.
2
Non-return valve
Cut through the compressed
air hose