User Manual E-by-SIPLACE 用户手册 - 第155页
User manual E by SIPLACE 3 Technical data and assemblies From software version SC 712.1 Edition 05/2019 3.9 Alternative E by SIPLACE feed er modules 155 3.9.3 SIPLACE LDU E The SIPLACE LDU E is used for coat ing flip chi…
3 Technical data and assemblies User manual E by SIPLACE
3.9 Alternative E by SIPLACE feeder modules From software version SC 712.1 Edition 05/2019
154
3.9.2.1 Safety instructions for the SIPLACE StickFeeder E
3
3
3
3
Heavy weight of the SIPLACE StickFeeder E!
The heavy weight of the SIPLACE StickFeeder E (14 kg) could cause
injuries if the module is not handled correctly.
Do not lift or carry the module alone.
Use lifting aids and proper lifting techniques when removing or
replacing.
You might need to enlist the help of a second person.
User manual E by SIPLACE 3 Technical data and assemblies
From software version SC 712.1 Edition 05/2019 3.9 Alternative E by SIPLACE feeder modules
155
3.9.3 SIPLACE LDU E
The SIPLACE LDU E is used for coating flip chips and CSP components with flux. The flux con-
tainer slides with a linear movement over the dip plate and coats the cavity in the dip plate with a
layer of flux (predefined layer thickness).The parameters for coating a component with flux are
prescribed in SIPLACE Pro. The component is coated and then the flux layer is renewed. This
sequence guarantees consistent processing conditions for the components. The SIPLACE LDU E
is taken into account as an independent feeder module type in the setup. An implemented warm-
ing function allows the viscosity of the flux to be altered. It occupies 9 locations of an 8 mm E
feeder module.
3
Fig. 3.9 - 2 SIPLACE LDU E
PLEASE NOTE
Not applicable for SIPLACE E-Pro
The SIPLACE LDU E is not applicable for SIPLACE E Pro.
3 Technical data and assemblies User manual E by SIPLACE
3.9 Alternative E by SIPLACE feeder modules From software version SC 712.1 Edition 05/2019
156
3.9.4 SIPLACE PowerAdaptor E
Item no. 03113102-xx SIPLACE PowerAdaptor E
The SIPLACE PowerAdaptor E provides power to a single feeder for offline setup. This device can
either be put on any flat table or can be attached to SIPLACE Preparation Table E (see Section
6.8 on page 304).
3
Fig. 3.9 - 3 SIPLACE Power Adaptor E
(1) Tape reel holder
(2) Guide profile for guiding feeder modules
(3) Pogo-pin interface
3.9.4.1 Description
The SIPLACE PowerAdaptor E allows SIPLACE SmartFeeder E to be used outside the machine
and setup area. The SIPLACE PowerAdaptor E consists of an aluminum frame with guide profile
for holding and guiding the feeder modules. As with the changeover table, the feeder module is
placed on the guide profile, with the slider guides, and is pushed forwards until the front centering
pin of the feeder module is fully inserted.
(3)
(2)
(1)