User Manual E-by-SIPLACE 用户手册 - 第191页
User manual E by SIPLACE 4 Setting up and commissioning From software version SC 712.1 Edition 05/2019 4.3 Setting up th e machine 191 4.3.6.1 Conveyor height 950 (Option) Item no. 03111069-xx Conveyor hei ght 950 block …
4 Setting up and commissioning User manual E by SIPLACE
4.3 Setting up the machine From software version SC 712.1 Edition 05/2019
190
Loosen the locking screw (2). This locking screw fixes the machine feet (3) and prevents it
falling down as soon as the clamp has been loosened.
Loosen the three clamping screws (5) + (6) on the adapter.
Loosen the other three machine feets (3) in the same manner.
Use the 30 mm spanner to adjust the height of each machine feet (3) at the setting screw (1),
so that the relevant conveyor height is achieved.
Align the machine in the X and Y direction with the machine spirit level.
4
Tighten the clamping screws (5) of each machine feet to a torque of 120 Nm.
Tighten the clamping screw (6) of each machine feet to a torque of 120 Nm.
Tighten the locking screws (2) of each machine feet.
PLEASE NOTE
For a description of how to align the machine in the X and Y directions, refer to the section
4.3.7
, page 193.
User manual E by SIPLACE 4 Setting up and commissioning
From software version SC 712.1 Edition 05/2019 4.3 Setting up the machine
191
4.3.6.1 Conveyor height 950 (Option)
Item no. 03111069-xx Conveyor height 950 block
4
Fig. 4.3 - 3 Conveyor height 950 block
(1) Block
(2) Bracket
(1)
(2)
4 Setting up and commissioning User manual E by SIPLACE
4.3 Setting up the machine From software version SC 712.1 Edition 05/2019
192
4
Fig. 4.3 - 4 Machine feet on conveyor height 950 block
(1) Conveyor height 950 block
(2) Bracket for additional securing to the machine floor
(3) Machine feet
4
Push the forks of the pallet jack under the machine. See also 4.3.2, on page 186.
With the pallet jack, raise the machine.
Place the four blocks (1) below the four machine feet.
With the pallet jack carefully lower the machine.
Align the machine feet within the circular step of these blocks and place the machine onto
these blocks (1).
Align the machine in the X and Y direction with the machine spirit level.
4
Secure the block with the bracket to the machine floor if necessary.
WARNING
Risk of injuries!
There is a risk of injury during assembly work to the underside of the machine!
Secure the machine using suitable measures. The pallet jack must not be used as
the only support.
Take care that your hands and feet can not be hit.
PLEASE NOTE
For a description of how to align the machine in the X and Y directions, refer to the section
4.3.7
, page 193.
(1)
(3)
(2)