00198382-03_UM_SIPLACE-CA4-V2_EN - 第180页
4 Setting up and commissioning Instruction manual SIPLACE CA4 V2 4.3 Setting up the placement mac hine From software versio n 713.0 Edition 12/2019 180 4 Fig. 4.3 - 1 1 Presetting the height of the outer machine feet (1)…
Instruction manual SIPLACE CA4 V2 4 Setting up and commissioning
From software version 713.0 Edition 12/2019 4.3 Setting up the placement machine
179
4
Fig. 4.3 - 10 Adjusting the placement machine in the X and Y directions
Use the fork wrench SW36 to adjust the setting screw M24x2x120 (item 1 in fig. 4.3 - 11, page
180
), so that the fluid in the machine spirit level does not deviate from its zero point at the
required conveyor height.
4 Setting up and commissioning Instruction manual SIPLACE CA4 V2
4.3 Setting up the placement machine From software version 713.0 Edition 12/2019
180
4
Fig. 4.3 - 11 Presetting the height of the outer machine feet
(1) Setting screw M24x2x120 for height adjustment
(2) Outer machine foot
(3) Clamping pieces
(4) Hexagon socket-head screw M24x90
Check the required board conveyor height.
Once the placement machine has been aligned, use the torque wrench to tighten the hexagon
socket-head screws M24x90 (item 4) to clamp the clamping pieces at all outer machine feet
(item 3).
4
Use the hook wrench to unscrew the middle machine feet roughly 135 - 145, until these are
positioned firmly on the ground.
Make sure that the middle machine feet are not screwed out too far, thereby unbalancing the
placement machine.
PLEASE NOTE
Vibration at low tightening torques!
The tightening torque is 130 Nm. A lower torque could cause the placement machine to
vibrate.
Use a sufficiently high tightening torque.
(4)
(2)
(1)
(3)
Instruction manual SIPLACE CA4 V2 4 Setting up and commissioning
From software version 713.0 Edition 12/2019 4.3 Setting up the placement machine
181
4
Fig. 4.3 - 12 Aligning and locking the middle machine feet
Use the spirit level to ensure that the placement machine is precisely aligned.
Use the fork wrench SW65 to tighten the lock nut M24 (item 3).
(1) Spacer
(2) Middle machine foot
(3) Lock nut M24