EUKYX-199-2100_G5S2_Instruction_Vol2_E - 第132页

EUKYX 2-19 199-2100 3.3 Operation 3.3 O per ation (C0 1 ) Function Dat a Graphic Development F2B15

EUKYX

2-18199-2100

3.1 Common SET

(B01_05)

Comp library placement offset

"Enable" or "Disable" for the use of the Component Library Placement Offset Function, is set in this

data box. When "Enable" is set, the system is operated based on the values set in the component

library.

(B01_06)

PCB Warpage [mm]

Specify the maximum value of the PCB upward warpage.

Whenever the data is changed, be sure to optimize the data.

• Data Input Range: 0.000 to 3.000

(B01_07)

Lot Name

The lot name of the pattern program is set in this text box.

Max. 39 characters are used for the setting.

The available characters are half-width alphabetical and numerical characters and symbols.

Even when this comment is not set, it does not inﬂuence on the machine performance.

(B01_08)

Comment 1 and Comment 2

Comments on the pattern program can be specified in these text boxes.

Up to 32 characters (alphanumerics and marks) can be used.

The performance of the machine is not affected by these comments. In other words, it has

nothing to do with or without these comments.

Note

Notice

EUKYX

2-19199-2100

3.3 Operation

(C01) Function Data

Graphic

Development

F2B15

EUKYX

2-20199-2100

3.3 Operation

(C01_01)

PEC recognition function

Select one of the following options to determine whether or not this function should be used.

Disable : The PEC recognition function is not used.

Enable : The PEC recognition function is used.

When the PEC recognition function is not used in a pattern program, the program cannot be

used.

(C01_02)

All (Zones 1 through 5)

When the "PEC recognition function" is to be used, the setting for the global recognition is selected

from the following items for each zone.

Disable : The global recognition function is not activated.

1 Point : The global recognition function is implemented, using one fiducial mark.

2 Point : The global recognition function is implemented, using two fiducial marks.

3 Point : The global recognition function is implemented, using three fiducial marks.

(a) It is recommended that "2 Point" or more should be selected for the global recognition.

(b) By dividing the area for the PEC recognition into several zones, it became possible to

correct a local expansion of a large PCB, etc.

Notice

Note