EUKYX-199-2100_G5S2_Instruction_Vol2_E - 第74页

EUKYX 1-24 199-2100 4.1 "Run Mode" T ab Sheet 4. 1 .3 "Run Mode" Wind ow in " Placement Reco ver y Av a ilable " Mode "Enab le" or "Di sable" for the NL -axis Orig in T e…

EUKYX

1-23199-2100

4.1 "Run Mode" Tab Sheet

4.1.2 "Run Mode" Window ("Warm Start" Possible)

When the machine is set in the "PAUSE" mode during the automatic operation, a warm start

operation becomes possible and the "Warm Start" window appears.

[1]

[2]

F2A21

[1] [Last Plc Pos Move] Button

When this button is pressed, the "Last Placement Point Check" window is opened.

[2] [Cancel Warm Start] Button

When pressed, the warm start is cancelled.

This button is displayed only in the window for the Supervisor. When the Warm start has been

stopped, the PCB is discharged without placing any component in the re-start operation. Pay

attention to it.

Refer to “5.3 Resumption of Production through Warm Start Procedure”

(Chapter 3 in Volume 1) for the detailed information on how to execute a warm start operation.

Note

Reference

EUKYX

1-24199-2100

4.1 "Run Mode" Tab Sheet

4.1.3 "Run Mode" Window in "Placement Recovery Available" Mode

"Enable" or "Disable" for the NL-axis Origin Teaching, is setup in this data box.

[1]

[2]

F2A22

[1] [Plc Pos Move] Button

When pressed, this button opens the "When the NL-axis origin teaching is to be performed, the

teaching time interval is selected from the following items." window.

A pre-pick nozzle conﬁrmation error will not occur when the pre-pick nozzle conﬁrmation

function is not used.

Refer to”4.2 “Opr.Mode” Tab Sheet” in "Chapter 1" for how to use the pre-pick nozzle

conﬁrmation function.

When the machine is reset to its normal condition from the "ERROR" window after a pre-pick

nozzle conﬁrmation error has occurred, the "Placement Step Recovery" window appears

automatically.

[2] [Cancel Place Rcvry] Button

When pressed, the placement recovery is cancelled.

Reference

Note

EUKYX

1-25199-2100

4.2 "Opr.Mode" Tab Sheet

When the [Opr.Mode] tab is pressed, the "Opr.Mode" tab sheet (1st page) appears as an initial one.

Every time the Page switch button [ ] is pressed, 2,3, or 4 page in the “Opr.Mode” is displayed.

[1]

Graphic

Development

"Opr.Mode" Tab sheet (1/4 page)

2/4 page

3/4 page

4/4 page

[2]

F2A23A

[1] “Opr.Mode” Select

The setting is performed in this area for the selected button.

When the setting has been changed, press the [Apply] button to apply the setting.

[2] Common Button

[Init Value] Button

When pressed, the set condition parameters are returned to the initial values.

[Apply] Button

When pressed, the changed setting is applied.

[Cancel] Button

When pressed the changed setting is returned to the one prior to the change.