00196056-0102 RI Shutterless 3x8 SL - 第29页
Introduction Spare Parts Nachrüstanleitung / Retrofit Instructions F eeder Module 3x8 mm S 0201/0402 to Shutterless ( 3X8 mm SL) 29 5.3 S p are Part s The following spar e parts can be ordere d for the shutterl ess tape …
Introduction
Tools and Equipment
28 Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to
5.2 Tools and Equipment
Tools
You will need various screws to fasten the side plates and the tape duct. These will differ, depending on
the function state of the 3x8 mm feeder. For conversion of the feeder, you will also need some of the
following tools:
Other Equipment
After the conversion, the information which converts the feeder into a shutterless feeder or back into an
S feeder needs to be saved in the EEPROM of the feeder. The feeder is assigned a new feeder ID. To
do this, you need to connect the feeder to a PC, on which the software for reprogramming the EEPROM
is installed: Set-SL-ID.
To reprogram the EEPROM, you require the following:
1 PC with at least one free COM port
1 CD SW shutterless feeder, Item No. 00387197-01. This CD contains:
– The software Set-SL-ID for programming the feeder EEPROM
– The retrofit guide "Conversion to Shutterless Feeder" (documentation)
1 interface unit for S feeders, Item No. 00371397-01 (1)
(order option)
1 power supply unit for SIPLACE feeders, Item No. 03041682-01 (2)
(order option)
Tools Size
Allen keys 1.3 / 1.5 / 0.7 / 2
Flat-bladed screwdriver 3 / 1
Phillips screwdriver 1
Torx screwdriver 0.8 / 0.6
Pozidriv screwdriver 1
Feeler gauge 0.25
NOTE:
The interface unit and the software Set-SL-ID, including this retrofit guide, can be ordered as
one set, specified as Equipment NRS Shutterless Feeder, Item No 00387190-01.
Introduction
Spare Parts
Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to Shutterless (3X8 mm SL)
29
5.3 Spare Parts
The following spare parts can be ordered for the shutterless tape duct:
Pickup window 3x8mm S – SL, Item No. 03054425-01
Tape support 3x8mm SL (spacer), Item No. 03014273-01
5.4 Safety Instructions
5.5 Display Features
Convention for the Use of Hazard Symbols
CAUTION:
The safety instructions in the documentation of the feeder which is to be converted to a
shutterless feeder take precedence.
Always observe the applicable accident prevention regulations and the special safety
regulations in your country for handling laboratory equipment or assemblies outside the
machine.
X
Indicates actions to be performed by the user
Bold lettering Indicates entries on the graphical user interface of the software Set-SL-ID
NOTE:
Is, for the purposes of this manual, key information about the product or part of the conversion
guide, which needs to be highlighted.
CAUTION:
Is, for the purposes of this conversion manual, a note indicating that minor injuries or damage
to property can occur, if the cautionary measures concerned are not observed.
Introduction
Display Features
30 Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to