00196056-0102 RI Shutterless 3x8 SL - 第39页

Replacing the Tape Duct Fixing the Flaps on the Shutterless Tape Duct Fitting the Shutterless Tape Duct Nachrüstanleitung / Retrofit Instructions F eeder Module 3x8 mm S 0201/0402 to Shutterless ( 3X8 mm SL) 39 7.2 Fitti…

Replacing the Tape Duct

Dismantling the Tape Duct Loosening the Flaps

38 Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to

7.1.4 Loosening the Flaps

X Loosen the screws marked in the diagram (1-

3), on the left and right of the tape duct.

X Lift the flaps off towards the front.

Replacing the Tape Duct

Fixing the Flaps on the Shutterless Tape Duct Fitting the Shutterless Tape Duct

Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to Shutterless (3X8 mm SL)

7.2 Fitting the Shutterless Tape Duct

7.2.1 Fixing the Flaps on the Shutterless Tape Duct

7.2.2 Fixing the Shutterless Tape Duct

X Push the flaps onto the shutterless tape duct,

from the front.

X Fix the flaps with the screws marked in the

diagram (1-3), on the left and right of the tape

duct.

X Make sure that the rubber foam seal is in the

position shown in the diagram.

This seal prevents components from falling down

the back and into the feeder.

Replacing the Tape Duct

Fitting the Shutterless Tape Duct Fixing the Shutterless Tape Duct

40 Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to

X Carefully bend the top of the protective cover

slightly forwards.

X Tilt the shutterless tape duct and push it onto

the feeder, from the front.

NOTE:

If you have only loosened the top two

screws on the protective cover, to avoid

damaging the warranty seal, you will

need to slightly tip the protective cover

forwards, so that the tape duct can

slide onto the feeder.

X Fix the shutterless tape duct onto the front of

the feeder, with the screws shown in the

diagram (1), on the right and left of the feeder.

X Use a feeler gauge (0.25 mm) to check the

tape duct distance, on the left and right of the

feeder. The tape duct should be parallel to the

drive housing.

NOTE:

As in the case of feeders of type

3x8mm S-tape 0201/0402 component

("Golden Feeder"), you do not need to

establish a connection between the

tape duct and the board.