00196056-0102 RI Shutterless 3x8 SL - 第41页
Replacing the Tape Duct Fixing the Shutterless Tape Duct Fitting the Shutterless Tape Duct Nachrüstanleitung / Retrofit Instructions F eeder Module 3x8 mm S 0201/0402 to Shutterless ( 3X8 mm SL) 41 X Fix the shutterless …
Replacing the Tape Duct
Fitting the Shutterless Tape Duct Fixing the Shutterless Tape Duct
40 Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to
X Carefully bend the top of the protective cover
slightly forwards.
X Tilt the shutterless tape duct and push it onto
the feeder, from the front.
NOTE:
If you have only loosened the top two
screws on the protective cover, to avoid
damaging the warranty seal, you will
need to slightly tip the protective cover
forwards, so that the tape duct can
slide onto the feeder.
X Fix the shutterless tape duct onto the front of
the feeder, with the screws shown in the
diagram (1), on the right and left of the feeder.
X Use a feeler gauge (0.25 mm) to check the
tape duct distance, on the left and right of the
feeder. The tape duct should be parallel to the
drive housing.
NOTE:
As in the case of feeders of type
3x8mm S-tape 0201/0402 component
("Golden Feeder"), you do not need to
establish a connection between the
tape duct and the board.
Replacing the Tape Duct
Fixing the Shutterless Tape Duct Fitting the Shutterless Tape Duct
Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to Shutterless (3X8 mm SL)
41
X Fix the shutterless tape duct onto the front of
the feeder, with the screws shown in the
diagram (2 and 3), on the right of the feeder.
X Fix the shutterless tape duct onto the front of
the feeder, with the screws shown in the
diagram (2-5), on the left of the feeder.
X Fix the shutterless tape duct to the top of the
feeder, with the screw (1).
Attention!
Tighten the screw carefully and not too tightly,
otherwise the aluminum thread could be
damaged.
X Use a feeler gauge (0.25 mm) to once again
check the tape duct distance, on the left and
right of the feeder. The tape duct should be
parallel to the drive housing.
If the distance is not correct, loosen the screw at
the top (1), those on the right (2 and 3) those on
the left (2-5) of the feeder and realign the tape
duct.
Replacing the Tape Duct
Fitting the Shutterless Tape Duct Fixing the Front Protective Cover
42 Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to
7.2.3 Fixing the Front Protective Cover
7.2.4 Fixing the Right-Hand Side Plate
X Fix the protective cover with the two screws (1
and 2) to the front of the feeder.
X Make sure that the cables – as shown in the
diagram - are run next to one another,
otherwise the side plate will protrude too much
later on.
X Lift the right-hand side plate onto the right side
of the feeder.
X Fix the side plate onto the right-hand side of
the feeder, with the screws shown in the
diagram (1-12) .
NOTE:
Make sure that you use the correct
screws to fix the side plate (in their
original positions).