00196056-0102 RI Shutterless 3x8 SL - 第43页
Changing the Feeder ID on the EEPROM Connecting the Interface Unit Nachrüstanleitung / Retrofit Instructions F eeder Module 3x8 mm S 0201/0402 to Shutterless ( 3X8 mm SL) 43 8 Changing the Feeder ID on the EEPROM After c…
Replacing the Tape Duct
Fitting the Shutterless Tape Duct Fixing the Front Protective Cover
42 Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to
7.2.3 Fixing the Front Protective Cover
7.2.4 Fixing the Right-Hand Side Plate
X Fix the protective cover with the two screws (1
and 2) to the front of the feeder.
X Make sure that the cables – as shown in the
diagram - are run next to one another,
otherwise the side plate will protrude too much
later on.
X Lift the right-hand side plate onto the right side
of the feeder.
X Fix the side plate onto the right-hand side of
the feeder, with the screws shown in the
diagram (1-12) .
NOTE:
Make sure that you use the correct
screws to fix the side plate (in their
original positions).
Changing the Feeder ID on the EEPROM
Connecting the Interface Unit
Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to Shutterless (3X8 mm SL)
43
8 Changing the Feeder ID on the EEPROM
After conversion or reassembly, the feeder ID on the feeder EEPROM needs to be updated.
8.1 Connecting the Interface Unit
The interface unit ensures the power supply and the data exchange between the PC and the feeder
connected to the interface unit. The power supply and the data line are combined in one cable in the
interface unit and are then run to the feeder.
X Connect the power supply cable of the
interface unit with the corresponding cable
from the power pack. Make sure that the red
dot is at the top of both connectors.
X Connect the inlet connector to the power pack.
X Connect the mains connector to an earthed
shockproof socket.
X Connect the serial port of the interface unit to
the COM port of your PC.
Changing the Feeder ID on the EEPROM
Connecting the Feeder
44 Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to
8.2 Connecting the Feeder
8.3 Programming the EEPROM
The software described here can be used to change the feeder ID for the 3x8 mm feeder connected to
the PC via the interface unit.The following options are available for this:
You can read the feeder ID currently set out of the feeder, without changing it, in order to check the
connected feeder.
You can assign a shutterless feeder ID to a feeder which has been converted to a shutterless feeder.
You can assign an S feeder ID to a feeder which has been converted back to an S feeder.
X Switch the power pack on.
X Switch the interface unit on.
X Start the software. To do this, click on the corresponding icon on your desktop.
The following dialog box will be shown:
X Connect the feeder to the interface unit, as
shown in the diagram. Make sure that the red
dot is at the top of the connector.
CAUTION:
The software described here is only suitable for processing 3x8 mm feeders. Make sure that you
only use 3x8 mm feeders with this software.
NOTE:
Make sure that the feeder you want to process is connected to the PC.