00196056-0102 RI Shutterless 3x8 SL - 第46页
Changing the Feeder ID on the EEPROM Attaching /Removing Labels 46 Nachrüstanleitung / Retrofit In structions Feeder Module 3x8 mm S 0201/0402 to 8.5 Att aching /Removing Labels The conversion turn s the 3x8 mm feeder in…
Changing the Feeder ID on the EEPROM
Disconnecting the Feeder
Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to Shutterless (3X8 mm SL)
45
X To exit Set-SL-ID, click on the exit button.
8.4 Disconnecting the Feeder
By clicking on the top button, you read the feeder
ID out of the connected feeder. This button s also
used to check whether a change to the feeder ID
was successful.
By clicking on the center button, you convert the
feeder ID to a Shutterless Feeder ID (feeder
3x8mm SL S-tape SIPLACE).
By clicking on the bottom button, you change the
feeder ID back to the ID for a standard 3x8mm S
feeder (feeder 3x8mm S-tape SIPLACE).
X Disconnect the feeder connector plug from the
interface unit.
Changing the Feeder ID on the EEPROM
Attaching /Removing Labels
46 Nachrüstanleitung / Retrofit Instructions Feeder Module 3x8 mm S 0201/0402 to
8.5 Attaching /Removing Labels
The conversion turns the 3x8 mm feeder into a shutterless feeder. This change needs to be documented
on the back of the device, so that the information can be seen when the feeder is in production, on a
changeover table.
X Stick the label provided in the retrofit kit - with the shutterless feeder item number (00141088-01) -
over the old label on the operating panel of the feeder, as shown in the diagram.
NOTE:
If you have converted the feeder back from a shutterless feeder to a conventional S feeder,
carefully (!) remove the shutterless feeder ID label again.
When removing the label, take care not to damage the old label with the S feeder item number
(00141098-01).