KE2040Instruction Manual Ver2.01,REV04.2003.6.25 - 第884页

13 − 44 13.13.9 Overv iew of the coplanarity check operation Mov ements of a component over the axis sensor during coplanar ity check are described below. 13.13.9.1 Bat ch component check The device scans a component who…

100%1 / 1491
13 − 43
13.13.8 Error processing
When the device detects an error as the result of coplanarity check, the system
displays an error log when it does not place an error component on a board.
Figure 13.13.8.1 Error dialog box
Figure 13.13.8.2 Pause dialog box
13 − 44
13.13.9 Overview of the coplanarity check operation
Movements of a component over the axis sensor during coplanarity check are
described below.
13.13.9.1 Batch component check
The device scans a component whose size is specified for “Batch measurement” in
(3) Measurement mode and dimensions of a component of Section 13.13.3 in a single
direction to measure it.
13.13.9.1 Batch measurement operation
13.13.9.2 Division component check
The device scans a components whose size is specified for “Division measurement”
in (3) Measurement mode and dimensions of a component of Section 13.13.3 as
shown in Figure below to measure it.
Figure 13.13.9.2 Division measurement operation
14 − 1
CHAPTER 14 MAINTENANCE
14.1 Daily Routine Checks
14.1.1 List of daily routine checks
WARNING
To prevent the body from injury which can be caused by accidental
activation of the machine, cut off the power to the machine before
starting to work.
Table 14.1.1
Items to be checked
Check and lubrication frequency
Maintenance
Check point
Check
Daily
Weekly
Monthly
Bimonthly
Every
half year
Every
year
Air pressure Check 0.49 MPa (5kgf/cm2).
○
Piping and joint Air leakage
○
Unit air cylinder Check operation.
○
Air filter (Head) No dirt
○
Air filter (CAL block)
○
Power on lamp Check if it is lit.
○
Transfer belt Worn out, damage, or stretch
○
Transfer pulley If it functions properly.
○
Check
Electric device Voltage, cables, and connectors Whenever necessary
X- and Y-axis direct drive units Remove dirt and oil.
○
Transfer belt Remove dirt and foreign substances
○
Transfer sensors Cleaning
○
Laser align sensor
○
Coplanarity sensor
Cleaning of the sensor window
○
Nozzle
Disassemble and cleaning inside the
nozzle
○
ATC bracket Remove dirt and oil.
○
Feeder bank Remove foreign substances.
○
Ejector Remove dirt and foreign substances.
○
Z slide shaft Cleaning inside the shaft.
○
OCC (Polarizing filter) C Remove dirt and foreign substances.
○
Cleaning
Track ball C Remove dirt and foreign substances.
○
X- and Y-axis direct drive unit rails Grease (EP2)
○
Transfer screw shaft (Shaft)
Grease (EP2)
○
Transfer guide shaft Grease (EP2)
○
PWB stopper part Grease (EP2)
○
Ball screw and LM guide rail (Head part)
Grease (CGrease)
○
Spline shaft (head part) Grease (CGrease)
○
Overall feeder exchange trolley Grease (EP2)
○
Support table Grease (EP2)
○
Movable transfer table section
(ball screw)
Grease (CGrease)
○
Lubrication
Movable transfer table section
(LM guide)
Smooth
movement
Grease (CGrease)
○